JBL Fuse Passive Dual Subwoofer Installation Guide
THANK YOU FOR YOUR PURCHASE .
Your JBL product has been designed to provide you with the performance and ease of operation you would expect from JBL.
ABOUT THE MANUAL
This manual describes general installation guidelines. However, please note that proper installation of mobile audio components requires qualified experience. If you do not have the knowledge and tools to successfully perform this installation, we strongly recommend consulting an authorized JBL dealer about your installation options. Keep all instructions and sales receipts for reference.
DIMENSIONS
MOUNTING THE FUSE
Vertical mounting
- Select a suitable location in the cargo area or trunk.
- Use the included screws to secure the feet to the mounting surface.
NOTE: Before drilling pilot holes for the mounting screws, check beneath the mounting surface to ensure you will not
puncture fuel lines, brake lines, or any vehicle wires.
Separating the twin enclosures
- Remove four screws securing the mounting feet; remove mounting feet.
- Remove speaker grilles.
- Remove four (4) bolts securing twin enclosures.
- Separate twin enclosures.
Floor mounting
- Select a suitable location, such as under a seat.
- Use the included bolts to secure to the mounting surface.
- Replace speaker grilles.
NOTE: Before drilling pilot holes for the mounting screws, check beneath the mounting surface to ensure you will not
puncture fuel lines, brake lines, or any vehicle wires.
Wiring the subwoofers
Connect the speaker outputs of your power amplifier to the spring terminals of the Fuse enclosures using 14-gauge speaker wire (not included).
NOTE: Be sure to observe proper wire polarity.
SPECIFICATIONS
| Continuous power handling | 200 watts RMS |
| Peak power handling | 600 watts |
| Frequency response | 30 Hz – 200 Hz |
| Nominal impedance | 2 ohms (parallel connection)
4 ohms separating twin enclosure |
| Sensitivity @ 2.83V | 90 dB |
