Loading manuals...

evenflo 5111344 Journey 100 Multi Color Stroller Manual


evenflo 5111344 Journey 100 Multi Color Stroller Manual Image

evenflo 5111344 Journey 100 Multi Color Stroller

FEATURES

Note:
Not all features shown in the instructions are available for all models. Some models feature an extra zipper access to cargo basket, larger wheels, rear suspension and carriage position, and wheel swivel locks.

WARNING
READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS! FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH!

  • NEVER leave child unattended. ALWAYS keep child in view while in the stroller.
  • Adult assembly required. Take care when unpacking and assembling; contains small parts and some items with sharp edges.
  • To prevent a possible choking hazard, remove and discard packing material before using this product.
  • Avoid serious injury from falling or sliding out. ALWAYS use waist restraint.
  • DO NOT carry or roll stroller on stairs or escalators with child in it.
  • DO NOT hang items on handlebar or place them on the canopy as they can tip stroller over and injure child.
  • Be sure stroller is fully assembled and locked in unfolded position before using.
  • ALWAYS exercise care when going over curbs or steps, and never use stroller for anything other than transporting your child. Push stroller at a normal walking pace only; faster strolling can cause a loss of control and injury to the child.
  • DO NOT load console or pockets with over 2.5 lbs (1.1 kg) total. DO NOT load the main cargo basket with over 10 lbs (4.5 kg) total. DO NOT load side/rear cargo pockets (if present) with over 2 lbs (.9 kg) per side/rear. Stroller may become unstable and tip over.
  • DO NOT place hot liquids in the console. Spills can burn your child.
  • DO NOT raise or recline seat with child in stroller.
  • DO NOT use stroller if any parts are missing or broken.
  • DO NOT allow child to climb on, into, out of or around stroller.
  • DO NOT allow child to stand on the footrest. The stroller may tip over and injure child.
  • DO NOT carry additional children, goods, or accessories in or on this stroller except as advised in these instructions. The stroller is intended for use with one child occupant and to accommodate only the additional weights in storage as listed in these instructions.
  • Care must be taken when folding or unfolding the stroller to prevent finger injury in hinge areas.
  •  NEVER leave stroller on a hill or incline, even with brakes set. The stroller may tip injure the child.
  • To avoid accidental rolling, ALWAYS set brakes when stroller is not being pushed.
  • AVOID STRANGULATION:
    • DO NOT suspend strings or toys from the canopy.
    • DO NOT place stroller anywhere near cords from window blinds, draperies, phone, etc.
    • DO NOT place items with a string around your child’s neck such as hood strings or pacifier cords.
  • When making adjustments to the stroller, ALWAYS ensure that all parts of the child’s body are clear of any moving parts of the stroller.
  • The canopy is not intended to provide UV protection.
  • Sharp or heavy objects placed in pockets may cause damage to the stroller or injury to the child.
  • If not properly secured, the child may slip into leg openings and strangle.
  • Only use the Evenflo Discovery™ infant car seat with this stroller. Other infant car seats or carriers are not designed to fit the stroller frame and may result in serious injury to your child if used with this stroller.
  • To ensure safety for your baby, please refer to the manufacturer’s instructions for the use of your infant car seat and keep all instructions available for reference.
  • DO NOT lift the stroller by using the infant car seat handle when installed on the stroller.
  • If unable to securely attach the infant car seat to the child’s tray on this stroller, remove the car seat and contact Evenflo ParentLink at
    1- 800-233-5921 (USA), 1-937-773-3971 (Canada), or 01-800-706-12-00 (Mexico).
  • To avoid serious injury to the child, when an infant car seat is in the stroller, make sure the infant car seat is securely snapped onto the child’s tray and secured with car seat stabilizer strap.
  • Some infant car seats have a blanket/boot option that must be removed for proper attachment to the stroller.

IMPORTANT INFORMATION

Child Requirements

  • Maximum weight: 40 lbs (18 kg)
  • Maximum height: 38” (96 cm)

IMPORTANT:
Read instructions carefully before use. Save these instructions for future reference. It is very important to assemble the stroller according to these instructions. DO NOT USE YOUR STROLLER UNTIL YOU HAVE READ AND UNDERSTOOD THESE INSTRUCTIONS. If you are missing parts, do not use the stroller and call Evenflo ParentLink at 1-800-233-5921 (U.S.A.), 1-937-773-3971 (Canada), or 01-800-706-12-00 (Mexico).

Registration Information
Please register this product so we can reach you if there is a safety alert or recall. We will not sell, rent, or share your personal information. To register your product, please complete and mail the card that came with it or visit our online registration at https://plweb.evenflo.com/productreg.aspx

IDENTIFICATION OF PARTS

ASSEMBLING YOUR STROLLER

  1. Place the folded stroller A on the floor so the parent’s console B is visible. Hold the parent’s handle C facing upward, as shown, then push it onto the stroller until it locks into place with audible clicks. Pull upward on the handle to make sure it is locked securely.
  2. Lift tube D at the rear of the cargo basket and push into tube E on the stroller until they lock into place with audible clicks.
    Pull upward on the basket to make sure it is locked securely.
  3. Unfold the stroller by unlocking the fold latch F, then grabbing the parent’s handle C and pulling upward. Make sure the stroller locks in the open position.
  4. Slide the footrest G downward and lock it into place.
  5. Begin assembly of the rear wheels and axle assembly by discarding all packaging. Slide one wheel H and a steel washer I onto axle J. Insert a clevis pin K through the end of the axle J to secure the wheel, as shown. Make sure the clevis pin is completely pushed through the hole in the axle, and make sure the brake housings L are facing the same direction. Note: An extra clevis pin and steel washer are included for your convenience. Install the hub cap M on the wheel by lining up the notch N with the tallest rib O in the wheel hub. Insert the hub cap completely until it snaps into place. Repeat on the other side.
  6. Slide the front wheel assembly S over the front frame leg T until the locking tab U locks into place with an audible click. Repeat for other side. Note: To remove each swivel wheel, press locking tab U and slide the wheel off the leg.
  7. Insert the canopy support tubes V into the canopy hinges on the stroller W until they lock into place with audible clicks. Pull upward on the canopy tubes to make sure they are locked securely.
  8. Bring the parent’s console B up to the parent’s handle C. Gently pull out the side of the console and guide the hole X over the post Y. Repeat on the other side of the parent’s console.

USING YOUR STROLLER

  1. Pull canopy hoop A forward to extend canopy. Push canopy toward handle to close.
  2. Step on the rear brake levers B to lock the rear wheels on the stroller. To release the brakes, lift up on the brake levers.
  3. To open the child’s tray C, slide the button D on either side of the tray, then lift tray upward.
    Note: You can open the tray from either side.
  4. DO NOT raise or recline seat with child in stroller. To recline seat, move the adjuster tab E all the way to the left and lower seat back F. To raise the seat, pull the D-ring G to the right. 
  5. Avoid serious injury from falling or sliding out. ALWAYS use waist restraint. Lock the rear brakes. Place the baby in the seat and bring the crotch panel H up between the child’s legs. Fasten each buckle I and pull the straps to tighten the waist and shoulder restraints (shoulder restraints only for 5 point) for a snug, comfortable fit. Note: To loosen straps, push in the release button J on the buckle and pull up.
  6. WARNING
    Care must be taken when folding or unfolding stroller to prevent finger injury in hinge areas.
    To fold the stroller, lock the rear brakes, close the canopy, and remove your child. Locate and raise the release handle K, as shown. Hold the release handle and the parent’s handle L and pull upward to unlock the stroller. Place one foot on basket M and push downward until the stroller is in the folded position. Lock the fold latch N.
    Note: Stroller will stand by itself.
    To unfold the stroller, unlock the fold latch N, then grab the parent’s handle and pull upward.

USING YOUR STROLLER WITH AN INFANT CAR SEAT

WARNING

  • Only use the Evenflo Discovery™ infant car seats with this stroller. Other infant car seats or carriers are not designed to fit the stroller frame and may result in serious injury to your child if used with this stroller.
  • To assure safety for your baby, please refer to the manufacturer’s instructions for the use of your infant car seat and keep all instructions available for reference.
  • DO NOT lift stroller by using the infant car seat handle when installed on stroller.
  • If unable to securely attach infant car seat to child’s tray to this stroller, remove the car seat and contact Evenflo ParentLink at
    1- 800-233-5921 (USA), 1-937-773-3971 (Canada), or 01-800-706-12-00 (Mexico).
  • To avoid serious injury to the child, when an infant car seat is in the stroller, make sure the infant car seat is securely snapped onto the child’s tray and secured with car seat stabilizer strap.

  1. Fully recline the seat back (page 6).
  2. Make sure the child’s tray A is securely latched.
  3. The infant car seat B MUST be in the rear-facing position. Lower the infant car seat down onto the child’s tray A and press downward until you hear the lock snap into place.
  4. Secure the front of the infant car seat B with the car seat stabilizer strap C. Slide the car seat stabilizer strap C through the locking channel D, as shown.
  5. Pull up on the car seat handle to test the lock.

To remove the infant car seat, disconnect the car seat stabilizer strap and disengage the seat release handle on the back of the infant car seat.

CHECKLIST FOR PROPER INSTALLATION

  • Make sure the infant car seat B is in the rear-facing position.
  • Make sure the infant car seat is securely locked onto the child’s tray A and secured with car seat stabilizer C.
  • Pull up on the car seat to test that it is properly locked into place.

CARE AND MAINTENANCE

  • Clean minor spills and stains on cloth, vinyl or plastic surfaces with cold water and mild soap. Air dry.
  • Metal and plastic parts can be wiped clean with a soft damp cloth and dried with a soft cloth. DO NOT use abrasive cleaners or solvents.
  • An occasional drop of vegetable oil may reduce wear and tear on moving parts.

LIMITED WARRANTY

For a period of 90 days from the original purchase of this Product, Evenflo warrants to the original end-user (“Purchaser”) this Product (including any accessories) against defects in material or workmanship. Evenflo’s sole obligation under this express limited warranty shall be, at Evenflo’s option, to repair or replace any Product that is determined to be defective by Evenflo and determined to be covered by this warranty.
Repair or replacement as provided under this warranty is the exclusive remedy of the Purchaser. Proof of purchase in the form of a receipted invoice or bill of sale evidencing that the Product is within the warranty period must be presented to obtain warranty service. This express limited warranty is extended by Evenflo ONLY to the original Purchaser of the Product and is not assignable or transferable to subsequent purchasers or end users of the Product. For warranty service, contact Evenflo’s ParentLink Consumer Resource Center at (800) 233-5921 or www.evenflo.com.
EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS HEREBY DISCLAIMED. EVENFLO SHALL NOT BE LIABLE FOR ANY INCIDENTAL, CONSEQUENTIAL, SPECIAL OR PUNITIVE DAMAGES OF ANY KIND FOR BREACH OF THE EXPRESS LIMITED WARRANTY ON THIS PRODUCT, OR ANY WARRANTY IMPLIED BY OPERATION OF LAW. OTHER THAN THE EXPRESS LIMITED WARRANTY SET FORTH ABOVE, THERE ARE NO OTHER WARRANTIES THAT ACCOMPANY THIS PRODUCT AND ANY ORAL, WRITTEN OR ANY OTHER EXPRESS REPRESENTATION OF ANY KIND IS HEREBY DISCLAIMED.

www.evenflo.com • USA: 1-800-233-5921 8 AM – 5 PM E.T.
Canada: 1-937-773-3971 •México: 01-800-706-12-00


More Manuals From evenflo