Item no. 019413
FM radio
with manual crank charging
FM-radio med manuell sveivlading
OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original instructions)
SAFETY INSTRUCTIONS
- Do not expose the product to rain or moisture – risk of fire and/or electric shock.
- Never open the casing – risk of electric shock. Service must only be carried out by qualified personnel.
- Preserve the service life of the battery by charging it regularly.
- To ensure normal functionality and long life span, do not expose the appliance to extreme temperatures or high relative humidity.
- Never put the appliance in the bathroom, or near a stove or radiator.
- If the appliance does not work correctly take it to the nearest service centre. Do not attempt to repair it yourself.
SYMBOLS
Read the instructions. | |
Approved in accordance with the relevant directives. | |
Recycle discarded product in accordance with local regulations. |
TECHNICAL DATA
Frequency range | 87-108 MHz |
Voltage | 3.7 V |
Size | H6 x W4.5 x D12.8 cm |
DESCRIPTION
FM radio med manual crank charging and LEDs.
- Radio antenna
- Frequency indicator
- Control dial
- Frequency band selector
- Radio ON/OFF + volume
FIG. 1 - Power switch torch
- Solar panel
FIG. 2 - Frequency indicator light
- Power status light
FIG. 3 - Standard USB port
- Micro USB port
FIG. 4
FUNCTIONS
- One or three bright white LEDs
- FM/A/NOAA
- Emergency charging of mobile phone
USE
USING THE RADIO
- Turn the volume dial clockwise to start the product and set the required volume.
- Select frequency band AM, FM or WB. Pull out the antenna for the best reception.
- Set the required radio station by turning the control dial.
The green frequency indicator light goes on when a station is localised.
USING THE TORCH
- Press the power switch to switch on the torch.
- Press the power switch again to switch off the torch.
SOLAR ENERGY/CRANK/USB PORT
- Place the product in sunlight for about 10 to 12 hours. The red status light goes on during charging.
CRANK
- Pull out the crank.
- Crank clockwise or anticlockwise for 3 to 5 minutes to activate the internal battery before using for the first time, or if the product has not been used for 60 days or more. The red status light goes on during cranking.
- To recharge, crank for 1 minute with at least 130 turns/ minute for 15 to 20 minutes of continuous light with 3 LEDs, 15 to 20 minutes of continuous radio with medium high volume, or 3 to 5 minutes of talk time. FIG. 5
CHARGING WITH USB PORT
- Lift the rubber cap on the side of the product.
- Connect one end of the charger cable to the micro USB port on the product and the other end to a USN port on a computer. The red status lamp goes on when the battery is charging.
CHARGING MOBILE PHONE, PDA, MP3 PLAYER ETC.
- Lift the rubber cap on the side of the product.
- Connect one end of the charger cable to the standard USB port on the product and the other end to the external device to be charged. FIG. 6
CHARGING/DISCHARGING PROTECTION
- The red status lamp goes off when battery is fully charged.
- The charging is stopped automatically on overcharging or short circuiting.
- The power supply function is deactivated automatically when the battery voltage drops below 2.5 V.
MAINTENANCE
- Clean the outside of the product with a damp cloth.
- Clean the glass cover with detergent for a camera lens or the equivalent.
- Do not clean the product with abrasive agents or solvent.
- This product is not watertight, just splashproof (protection rating IPV3).
Do not immerse the product in water or any other liquid. - Before using for the first time, or if the product has not been used for 60 days or more, expose the solar panel to sunlight or crank for 3 to 5 minutes to charge the internal battery.
Jula reserves the right to make changes.
For latest version of operating instructions, see www.jula.com
EU DECLARATION OF CONFORMITY
Item number Jula AB, Box 363, SE-532 24 SKARA, SWEDEN
This declaration of conformity is issued under the sole responsibility of the manufacturer.
MRADIO WITH CRANK CHARGING
Conforms to the following directives, regulations and standards:
Directive/Regulation | Harmonised standard |
RED 2014/53/EU | EN 62368-1:2014+A11, EN 62479:2010, ETSI EN 301 489-1 V2.2.3 Draft ETSI EN 301 489-52 V1.1.2, ETSI EN303 345-1 V1.1.1, ETSI EN 303345-3 V1.1.1 |
RoHS 2011/65/EU + 2015/863 | EN 50581:2012 |
This product was CE marked in year:
Skara 2021-09-30
CHRISTIAN BLANK
BUSINESS AREA MANAGER
DoC: EN-SE-NO-PL-DE-FI-FR-NL