CAT CJ1000DCP Jump Starter and Compressor manual

CAT CJ1000DCP Jump Starter and Compressor

THIS QUICK START GUIDE IS NOT A SUBSTITUTE FOR THE INSTRUCTION MANUAL. PLEASE REFER TO THE INSTRUCTION MANUAL AND YOUR VEHICLE’S USER’S MANUAL BEFORE USE.

IMPORTANT CHARGING INSTRUCTIONS

Immediately charge this unit for a full 40 hours upon receipt. This unit’s internal battery is shipped in a partially charged state and must be fully charged before use.
Fully charge the unit immediately after purchase, every 30 days, and after each use. Lead-acid batteries can lose charge over time. Regular recharging can optimize performance and battery life.

DIGITAL DISPLAY

ICON	SOLID	FLASHING
	Unit is fully charged	Unit is charging
	USB power is ON
	Compressor feature has been selected	Compressor feature is ON
	Vehicle has started	Ready to Jump-start
		System fault detected*
	Correct Clamp connection
	Reverse Clamp connection

Consult the TROUBLESHOOTING section of the Instruction Manual for further info.

REVERSE POLARITY ALARM

When battery clamps are connected in reverse polarity, an audible alarm (continuous beep) will sound and the LCD screen will display the Reverse Polarity Indicator icon (please see Instruction Manual for details). DO NOT activate the jump starter. If this happens carefully disconnect the clamps and re-connect with the proper polarity. Ensure that the grounded clamp has a ﬁrm and clean connection.

USING THE AIR COMPRESSOR

To prevent overheating, Air Compressor will automatically shut off after 10 minutes. Please allow a 30-minute cooldown before resuming inﬂation. Note that the Air Compressor will store the last PSI setting in memory, making it easier to regularly top off your vehicle’s tires.

USB POWER

Press the USB button on the control panel.
Plug the electronic device into any of the USB Ports and operate normally.
LCD Screen will display Voltage Indicator and USB Power On icon.

©2020 Caterpillar. CAT, CATERPILLAR, BUILT FOR IT, their respective logos, “Caterpillar Yellow,” “Caterpillar Corporate Yellow,” the “Power Edge” trade dress as well as corporate and product identity used herein, are trademarks of Caterpillar and may not be used without permission. ONE YEAR LIMITED WARRANTY: This product is covered by a one (1) year limited warranty. See the instruction manual for full details. TO REDUCE THE RISK OF INJURY, THE USER MUST READ THE INSTRUCTION MANUAL. The product in this box may differ slightly from that pictured. Not all objects are included. Baccus Global, a licensee of Caterpillar Inc. US Patent No. D761,200. *Sure Fit® is a registered US trademark and Set & Forget™ is a US trademark owned by Baccus Global LLC. This unit was designed for household use only.

FAQ’S

How do I charge the unit?

The unit can be charged by connecting an AC power source to the DC input port on the back of the unit.

How long will it take to charge?

It will take approximately 40 hours to fully charge a completely discharged unit.

How long will a full charge last?

A fully charged battery should provide enough power to start an average size vehicle up to 20 times. If you are using the compressor, it will reduce the number of jump-starts you can do before recharging.

How long does it take to recharge?

It takes approximately 10 hours to recharge a completely discharged unit.

What is reverse polarity alarm and what should I do if I hear it?

When battery clamps are connected in reverse polarity, an audible alarm (continuous beep) will sound and the LCD screen will display the Reverse Polarity Indicator icon (please see Instruction Manual for details). DO NOT activate the jump starter. If this happens carefully disconnect the clamps and reconnect them properly. If this happens again, please contact your authorized service center or call Customer Service at 1-800-732-6839 for assistance.

How do I charge my cat jump starter?

CHARGING/RECHARGING
Open the AC adapter cover located on the back of the unit and connect an extension cord to the unit. Plug the other end of the cord into a standard 120-volt AC wall outlet.
Charge until the green LED Battery Status Indicator lights solid.
Once fully charged, disconnect the extension cord.

Can a jump starter charge a battery?

A jump pack — a more conveniently designed portable jump-starting device — is the modern solution for how to charge a dead battery in your car. You can even use them on your own, without the need for another person or connecting to a running vehicle.

How many volts is a car battery?

12.6 volts
When we take a closer look, we see car battery voltage can range anywhere from 12.6 to 14.4. With the engine off, the fully charged car battery voltage will measure 12.6 volts. This is known as “resting voltage.” When the engine is running, battery voltage will typically rise to 13.5 to 14.5 volts.

Where is the reset button on a generator?

Reset Breaker for Power Tech Generators. Reset breakers are located on the control box of your generator along with the main on/off switch and main breakers. Reset breakers protect the circuit from surges. When your generator experiences a surge, these breakers need to be pushed in to be reset.

How long does cat jump starter battery last?

Typically as a general rule 24 – 48 hours immediately after purchase and after every use. It is also recommended to recharge every 30 – 60 days for approximately 12 hours or until the battery status indicators show full when the product is not in use.

How do you know when a jump starter is fully charged?

Usually an indicator light on the jump starter tells you when a recharge is necessary. Simply insert the power adapter into an outlet and charge the battery until the light indicates a complete charge.

What does 1000 peak amps mean?

Generally speaking, a jump starter with a higher peak amp rating is more powerful than one with a lower peak amp rating. Peak amps typically ranger from 300 to 1000 amps with some very powerful ones exceptionally reaching over 3000 amp.

CAT CJ1000DCP Jump Starter and Compressor
www://catautopower.com/