BUFFALO DB177 Salamander Grill Manual

Salamander Grill
Instruction manual
Model:DB177

Safety Tips

Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
Consult Local and National Standards to comply with the following:
– Health and Safety at Work Legislation
– BS EN Codes of Practice
– Fire Precautions
– IEE Wiring Regulations
– Building Regulations
Some surfaces become hot during operation – take care when using the appliance.
DO NOT immerse the appliance in water.
DO NOT clean with jet/pressure washers.
DO NOT carry when hot.
DO NOT leave the appliance unattended during operation.
DO NOT obstruct or cover the appliance in any way when in use.
During and after cooking, the unit is still hot. Never touch the surface to avoid scalding.
Not suitable for outdoor use.
Always switch off and disconnect the power supply to the appliance when not in use.
This appliance must only be used in accordance with these instructions and by persons competent to do so.
Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.
If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified technician in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Buffalo recommends that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing.

Product Description

DB177 – Salamander Grill

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your BUFFALO product.

Pack Contents

The following is included:

BUFFALO Salamander Grill
Grill Rack
Crumb Tray
Instruction manual

BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.

Operation

Connect the appliance to the mains power supply. Then turn on the switch.
Set the thermostat to the desired temperature (100°C-300°C). The power indicator light comes on and the appliance begins to heat up.
Note: 200°C to 220°C is sufficient for general cooking.
The power indicator light turns off when the appliance has reached the set temperature.
Place the foodstuffs in the appliance and cook as required.

Cleaning, Care and Maintenance

Always turn OFF the appliance and disconnect from the power supply before cleaning.
Allow the appliance to cool before cleaning.
Use warm, soapy water and a damp cloth to clean the exterior of the appliance.
Dry thoroughly after cleaning.
A BUFFALO dealer or qualified technician should carry out repairs if required.
Crumb Tray
Periodically remove the crumb tray and empty it.
Warning: Do not remove the tray during or immediately after use as it will be hot.
Clean the crumb tray using warm, soapy water.

Troubleshooting

Fault	Probable Cause	Solution
Appliance not working	The unit is not switched on	Check the unit is plugged in correctly and switched on
	Plug and lead are damaged	Call BUFFALO agent or qualified Technician
	Fuse in the plug has blown	Replace the plug fuse
	Power supply	Check power supply
	Internal wiring fault	Call BUFFALO agent or qualified technician
The appliance does not reach set temperature	Faulty thermostat	Call BUFFALO agent or qualified technician
The appliance does not reach set temperature	Faulty element	Call BUFFALO agent or qualified technician
The appliance heats up but the indicator light does not come on	The indicator light has expired	Call BUFFALO agent or qualified technician
Power indicator light comes on but the appliance does not heat up	Faulty element	Call BUFFALO agent or qualified technician
	Faulty thermostat	Call BUFFALO agent or qualified technician
	Thermostat set incorrectly	Check thermostat
Appliance slow to heat up	Faulty element	Call BUFFALO agent or qualified technician

Technical Specifications

Model	Voltage	Power	Current	Dimensions H x W x D mm	Weight
DB177	230V, 50Hz	2800W	12.2A	302 x 386 x 643	13kg

Electrical Wiring

This appliance is supplied with a 3 pin BS1363 plug and lead.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:

Live wire (colored brown) to the terminal marked L
Neutral wire (colored blue) to the terminal marked N
Earth wire (colored green/yellow) to terminal marked E

This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency, disconnection is required they must be readily accessible.

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities. BUFFALO products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO. Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to change specifications without notice.

DECLARATION OF CONFORMITY

+44 (0)845 146 2887 UK

Equipment Type	Salamander Grill Quartz Salamander Grill
Model	DB177 DB183
Application of Council Directives(s)	EN 60335-1:2012 +A11:2014 +A13:2017 EN 60335-2-48:2003 +A1:2008 +A11:2012 EN 62233:2008 Electro-Magnetic Compatibility (EMC) Directive 2014/30/EU EN 55014-1:2017 EN 55014-2:2015 EN 61000-3-2:2014 EN 61000-3-3:2013 Restriction of Hazardous Substances Directive (RoHS) 2015/863 amending Annex II to Directive 2011/65/EU
Producer Name	Buffalo
Producer Address	Fourth Way, Avonmouth, Bristol, BS11 8TB United Kingdom	42 North Point Business Park New Mallow Road Cork Ireland