Honeywell Home VTL15 Thermostatic Radiator Valves
Cautions:
- 2 – 130°C (36 – 266°F) Max. 10bar (145 psi) KVS = 0.70 m3/h Head connection M30x1.5
- For reliable and quiet operation: pmax = 1.0bar for Copper pipes only
- Reverse Flow TRVs
- Valve body approved for Keymark (EN215)
MODELS
Installing the thermostatic valve and head
- Fit tailpiece into radiator using PTFE Tape.
- Cut pipe cleanly and fir TRV body to radiator.
- Repeat for Lock shield.
- Turn head to 5
- Fit the TRV head and tighten onto the valve.
- Drain-off tailpieces can be ordered separately as VA15-DO/B (bulk pack of 15 pcs)
Integrate Balancing Insert
VT15/VTL15 TRVs can be balanced using either the Integrated Balancing Insert or the Lockschield Valve. Learn how to balance using the Integrated Balancing Instert at homecomfort.resideo.com/TRV
Setting temperature range limits on the thermostatic head
The TRV limits are set by using the ‘clip on’ tool to push one or both of two metal pins in the lower part of the head up into the top part of the head. They are removed by pushing them back again.
Example : Maximum at setting 4, minimum at setting 2
What is a thermostatic radiator valve (TRV)
Thermostatic Radiator Valves sense the air temperature around them and control the flow of water through the radiator which they are fitted to.
- TRV limt the temperature whithin each room and do not directly control the boiler, the boiler is switched by other controls such as Timers, Programmers, etc
- Turning a TRV to a higher setting will not make the room heat up any faster because this depends upon the boiler size and setting and the radiator size.
- UK Building regulations recommend a TRV to be fitted in each room except the one with the Room Thermostat.
- To save energy, turn each TRV only to a setting which is appropriate to its use.
- TRVs need a free flow of air to sense the temperature, so they must not be converted by curtains or blocked by furniture.
- For a clear understanding of your heat controls and how they work, ask your installer or visit the Homeowner section of heatingcontrols.honeywellhome.com
How to use
- Set the TRV to a setting corresponding to a temperature appropriate for the room.
- Turning the head to a higher setting may result in waste of energy without shortening the time to heat up the room. Oversupply of heating water brings only a negligible increase of the heat coming from the radiator.
- Turn the head to the antifreeze protection setting when you open a window.
For more information
homecomfort.resideo.com/europe
Manufactured for and on behalf of the Pittway Sàrl, La Pièce 4, 1180 Rolle, Switzerland by its Authorised Representative Ademco 1 GmbH
MU2H-2123GE25 R0121
Subject to change
© 2021 Pittway Sàrl. All rights reserved. This document contains proprietary information of Pittway Sàrl and its affiliated companies and is protected by copyright and other international laws. Reproduction or improper use without specific written authorisation of Pittway Sàrl is strictly forbidden. The Honeywell Home trademark is used under license from Honeywell International Inc.
UK Head Office
Ademco 1 Limited
200 Berkshire Place
Winnersh Triangle
RG41 5RD Berkshire heatingcontrols.honeywellhome.com
