kingfisher TTL488GDO Bent Shaft Petrol 2 in 1 Grass and Hedge Trimmer
TROUBLESHOOTING
WARNING! Suspected malfunctions are often due to causes that the user can fix themselves Therefore check the product using this section. In most cases the problem can be solved quickly.
WARNING! Only perform the steps described within these instructions! All further inspection, maintenance and repair work must be performed by an authorised service centre or a similarly qualified specialist if you cannot solve the problem yourself!
Problem | Possible cause | Fault correction |
Engine doesnot start | Notenough fuel in the fuel tank | Add fuel |
Primer has not been pressed at coldstart | Press the primer and restart | |
Primer has been pressed al warm start | Dryspark plug | |
Spark plug is wet | Dry spark plug | |
Spark plug is damaged | Replace the spark plug | |
Spark plug connector lose | Attach properly | |
Engine stops | Not enough fuel in the fuel lank | Add fuel |
Cutting device is blocked | Remove the blockage | |
Unsatisfactory cutting performance | Cutting blade is dull/damaged | Have a specialist to sharpen or replace it |
Cutting material exceeds
capacity |
Only cut materials acc. to
the capacity of the product |
|
Excessive vibration/
noise or is smoking excessively |
Cutting device is dull/damaged | Replace with a new one replace it |
Bolts/nuts are loosen | Tighten bolts/nuts | |
Petrol/oil is incorrect | Empty unused petrol/oil and refill with the correct petrol/oil |