Quick
Installation Guide
Range Extender
For technical support, the user guide, and more information, please visit http://www.mercusys.com/en/support.
Power on
Plug the extender into a power outlet near your router, and the Signal LED turns solid red.
Connect to the extender
Connect your wireless device to the extender’s network MERCUSYS_RE_XXXX.
Note: The default SSID (network name) is printed on the product label at the back of the extender.
Configure
- Launch a web browser and enter http://mwlogin.net. Create a password for future login attempts.
- Select your router’s host network and enter the
network password when prompted. - Check the Signal LED on your extender. A Green or orange LED indicates a successful connection.
Relocate
To achieve better signal quality, plug in the extender halfway between your router and the Wi-Fi dead zone.
Enjoy!
Connect your device to the extender using the extended SSID. The default Wi-Fi password is the same as your host network.
LED Explanation (For Range Extender Mode)
| Off | The power is off. |
| Blinking | The extender is starting or connecting to the host network. |
| Solid Red | The extender is not connected to the host network. |
| Solid Green | The extender is connected to the host network and works well. |
| Solid Orange | The extender is connected to the host network, but is too far away from the router. |
FAQ (Frequently Asked Questions)
Q1 How do I configure the extender using WPS?
- Plug the extender into a power outlet near your router, and wait until the Signal LED is lit and solid red.
- Press the WPS button on your router.
- Within 2 minutes, press the WPS or RESET/WPS button on the extender. The LED should change from blinking to a solid state, indicating a successful WPS connection.
Q2 How do I reset the extender?
- With the extender powered on, press and hold the Reset or RESET/WPS button until the Signal LED turns off, then release the button. When the Signal LED turns solid on, the reset process is complete.
Q3 What should I do if I cannot access the extender’s web management page?
- Make sure your wireless device is connected to the extended network using the extended SSID.
- Verify that http://mwlogin.net is correctly entered in the web browser.
- If you are using a computer, make sure it is set to obtain an IP address automatically.
- Refer to Q2 to reset the extender and try again.
