Shark ROCEKT PRO Powerfins Cordless Vacuum manual

Shark ROCEKT PRO Powerfins Cordless
 Vacuum User Guide

sharkclean.com/support
registeryourshark.com

WHAT’S INSIDE:

(A) Handheld Vacuum
(B) PowerFins Floor Nozzle
(C) Wand w/Handheld Storage Clip
(D) Crevice Tool
(E) Upholstery Tool
(F) Charger
(G) Anti-Allergen Brush
(H) Li-Ion Battery (Pre-Installed)
(i) HEPA Post-Motor Filter (Pre-Installed)

ASSEMBLY

For complete maintenance instructions, see the enclosed Owner’s Guide. For additional parts and accessories, visit sharkaccessories.com. For additional batteries and charging accessories, visit sharkclean.com/batteries.

POWER SETTINGS

OFF

Slide switch to the top to turn off power. To begin vacuuming in Standard Mode, slide switch to the appropriate setting.

BARE FLOOR SETTING

Bare Floor/Area Rugs Slide switch to the middle. The brush roll spins slowly to clean bare floors and small area rugs.

CARPET SETTING

Carpet Slide switch to the bottom. The brush roll spins faster to pick up debris below the surface of your carpets.

BOOST MODE

For an added boost in power, pull the Trigger on the handheld vacuum. Release it to return to standard power.

NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please select the Carpet setting and pull the trigger to go into Boost mode.

NOTE: Select Carpet setting for stuck-on dirt and debris.

CHARGING

Easily Insert or Remove the Li-Ion Battery
To insert, slide the Battery into the slot in the back of the handheld vacuum. To remove, press and hold the Battery Release Button then slide out the battery.

LI-ION BATTERY

NOTE: Full charge takes approximately 3 hours.

NOTE: The battery comes partially charged. Charge fully before first use.
Battery Runtime

VERSATILE CLEANING

Slide the power button to the desired power setting. Place your foot on the floor nozzle and tilt the handheld vacuum back.

NOTE: Brush roll will only engage when the handle is tilted back.

To detach the wand for above-floor cleaning, stand the vacuum upright, then press the Nozzle Release button on the bottom of the wand and pull the wand up to disconnect it.

OR
To detach the handheld vacuum, press the Wand Release button and lift the handheld vacuum off the wand.