Shark Rocket Pet Pro Vacuum
WHAT’S INSIDE:
A Handheld Vacuum
B PowerFins Floor Nozzle
C Wand w/Handheld Storage Clip
D Crevice Tool
E Dusting Brush
F Pet Multi-Tool
G Anti-Allergen Brush
H Charger
I Li-Ion Battery (Pre-Installed)
J HEPA Post-Motor Filter (Pre-Installed)
ASSEMBLY
POWER SETTINGS
OFF:
Slide switch to the ,top to turn off power.
To begin vacuuming in Standard Mode, slide switch to the appropriate setting.
BARE FLOOR SETTING:
Bare Floor/Area Rugs Slide switch to the middle. The brushroll spins slowly to clean bare floors and small area rugs.
CARPET SETTING:
Carpet Slide switch to the bottom. The brushroll spins faster to pick up debris below the surface of your carpets.
BOOST MODE:
For an added boost in power, pull the Trigger on the handheld vacuum. Release it to return to standard power.
CHARGING
Easily Insert or Remove the Li-Ion Battery
To insert, slide the Battery into the slot in the back of the handheld vacuum. To remove, press and hold the Battery Release Button then slide out the battery.
LI-ION BATTERY
In Use
Charging
NOTE: Full charge takes approximately 3 hours.
VERSATILE CLEANING
Slide the power button to the desired power setting. Place your foot on the floor nozzle and tilt the handheld vacuum back.
NOTE: Brush roll will only engage when the handle is tilted back.
To detach the wand for above-floor cleaning, stand the vacuum upright, then press the Nozzle Release button on the bottom of the wand and pull the wand up to disconnect it.
OR
To detach the handheld vacuum, press the Wand Release button and lift the handheld vacuum off the wand.
THEN
Attach a cleaning accessory, then choose the power setting.
EMPTYING THE DUST CUP
- To empty the dust cup, first disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling up on the handheld vacuum.
- Position the dust cup over a trash bin and slide the CleanTouch™ Dirt Ejector forward.
