USER MANUAL
Skullcandy Push Ultra
Auto Pair Mode
Auto Power- On
Charge Earbuds
Charge Case
Pairing Mode
Pair New Device
Power-On
Power – Off
Play/Pause
Track Forward
Track Back
VolumeUp
Volume Down
Answer/End
Activate Voice Assistant
Clear Paired Device
Tile Enabled: Download the App
Pair Tile
3EQ Modes
Questions Visit: www.skullcandy.com
Speaker Dnver: 12mm, Impedance: 320hms, 1HD <3%@1 KHz. Voltage Regulation:
Skulcandye,anc1 other Mari<s are registered trademark<s of Skullcandy, Inc. All rights
Maximum operating temperature 4S’C.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
- that to which the receiver is connected.
- — Consult the dealer or an experienced radio/TV technician for help.
ISED SAR Compliance Statement
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body.
