Sunco Lighting Disk LED Downlight (15W)
COMPONENTS
EASY INSTALLATION
SURFACE MOUNT-JUNCTION BOX
- Turn off circuit breaker that provides power to the light switch for the recessed lights.
• This fixture is compatible with a 4 inch and 6 inch junction box
- Remove the lens by twisting clockwise.
- Connect the supply wires to the junction box wires using the wire nuts provided.
• White to white
• Green to green
• Black to black
- Tuck the connected wires inside the junction box.
- Align junction box with holes on the fixture that correspond to the size (4” or 6”).
- Attach the fixture to the junction box with either short or long screws pending on the junction box (deep or shallow).
DO NOT OVER TIGHTEN.
- Complete the installation by screwing the lens back into place (counter clockwise).
- Turn on circuit breaker and test the light.
WARNING
All electrical connections must be in accordance with local and National Electric Code (N.E.C.) standards. Consult a qualified electrician if you are unfamiliar with proper electrical wiring connections. Please review these instructions carefully before proceeding.
WARNING: Risk of fire or electric shock. Do not alter, relocate or remove wiring during installation.
WARNING: Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation
SPECIFICATIONS
| Voltage | 120V |
| Wattage | 15W |
| Suitable for Locations Ingress | Damp |
| Housing | Polycarbonate |
| Weight | 0.39lbs |
| Warranty | 7 years |
COMPONENTS
EASY INSTALLATION
RETROFIT INSTALLATION-CAN
- Turn off circuit breaker that provides power to the light switch for the recessed lights.
- Locate the housing.
• Remove previous fixture, fixture may be hot so allow time to cool after turning off power
- Remove the lens by twisting clockwise.
- Place the springs into the keyhole slots on the back of the fixture using the Metric screws provided.
Using a screwdriver, gently tighten in place.
• Slot placement should be chosen based on can size (5” or 6”).
- Connect the supply wires to the TP24 adapter wires using the wire nuts provided.
• White to white
• Black to black
• It is highly recommended that a licensed electrician installs the ground wire to the box, if not already included in your existing can.
- Connect the TP24 adapter to the TP24 connector inside the recessed can.
- Attach ground wire to the grounding screw located inside the can.
- Pinch springs and line up trim ring with opening.
- Hook disk springs into housing.
• Strong springs. Use caution when compressing springs to fit inside can. Springs can bounce back quickly and cause injury.
- Push disk into recessed can until secure
- Complete the installation by screwing the lens back into place (counter clockwise).
- Turn on circuit breaker and test the light.
