Tzumi AquaBoost Floatingproof Speaker Manual

User Manual

Tzumi AquaBoost Floatingproof Speaker

PRODUCT OVERVIEW

Volume +/Next Song
Power
Volume -/Previous Song
Play/Pause/ Answer/Refuse Call
Micro USB port
Aux
LED Indicator
Microphone

CHARGING YOUR SPEAKER

The battery must be fully charged prior to use. It takes approximately 3 hours to fully charge your speaker (from depleted unit).

Red light ON – unit charging
LED OFF – unit fully charged

Via AC Adapter/Wall Charger: Using the provided Micro USB cable, connect your speaker to (Micro USB port) a power source such as an AC USB adapter

Via Computer: Using the provided Micro USB cable, connect your speaker (Micro USB port) to the computer/laptop (USB port).

PAIRING THE SPEAKER TO BLUETOOTH DEVICE

Make sure the Bluetooth function is available and enabled on your smartphone. Specific pairing procedures will be different depending on different device models. For detailed information, please refer to your smartphone’s User Guide.

If no device connection is made within 10 minutes of the speaker being switched on, the speaker will automatically be switched off to save power.
After a successful pairing, devices will memorize each other. Therefore, no pairing will be needed next time.

Keep the distance between your device and the speaker within 3 feet (for pairing only).
Turn on the speaker by pressing and holding the Power Button for 3 seconds.
The tone prompt will sound and the LED light will flash blue. The unit will automatically enter into pairing mode.
Activate the Bluetooth function of the device to search for all nearby available Bluetooth devices. After finishing the search, select “Tzumi-AquaBoost” in the device list displayed.
Your AquaBoost Speaker is ready for use.

SPEAKER CONTROLS

ON/OFF
Press and hold button for 3 seconds to turn the unit ON. Press and hold the button again to turn it OFF. The unit will turn itself off if inactive for 10 minutes.

VOLUME

Volume +
Press and hold + Button.
Volume –
Press and hold – Button.

MUSIC

NOTE: The Music Function Control only works with Bluetooth devices that support the A2DP profile.

Go to next song
Press + Button

Go to previous song
Press – Button.

PLAY/PAUSE/ANSWER/REFUSE THE CALL

Press button to answer the call, press it again to hang up.
Press and hold button for 2 seconds to refuse the call.
Double press button to call back the last number.
To hang up the call press it again.

TO RESET UNIT
Press and hold the and at the same time around 6 seconds to reset the speaker to its original setting.

AUX MODE

Use the 3.5mm audio cable (included) to connect the speaker to an audio source (MP3/MP4, mobile phone, computer). A tone will sound. The speaker will play the music from the audio source.

IMPORTANT SAFEGUARDS

Keep speaker away from any source of heat.
Always adjust the speaker volume to a suitable level to avoid hearing damage or the damage to the unit.
If not using the speaker for a long period of time, keep the internal battery charged (charge once every 3 months). This will extend the life of your lithium battery.

SPECIFICATIONS

Frequency: 120 ~ 20KHz
Battery: 2000mAh/3.7V
Bluetooth version: V4.2
Distance: 33 ft (10m)
Charging time: up to 3 hours
Playing time: up to 8 hours
Speaker unit Diameter: D45mm

©Copyright 2017 iPhone is a trademark of Apple Inc. Registered in the US and other countries. Bluetooth SIG, Inc. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by tzumi® is under license. Other trademarks and trade names are thoseof their respective owners. Subject to change without prior notice.