verizon QTAX56 Gizmo Watch Disney Edition Manual

QTAX56 Gizmo Watch Disney Edition
User Guide

Product Safety and Warranty Information

GizmoWatchTM Disney Edition

Health and Safety Information

This section outlines the safety precautions associated with using the device.

Important Safety Precautions

Please read the safety and operation instructions before using your device or any accessories that came with it. Retain these instructions for future use.

Do not install your device in your vehicle or use it while driving. Using your device while driving could put you and others at greater risk of an accident causing serious injury, death, and property loss. You are responsible for knowing and obeying the laws and regulations regarding the use of wireless devices in the areas where you drive.
This device has been tested to be IPx7 compliant. Do not operate underwater. If all covers are tightly closed, the device is protected against water ingress to a maximum of 1 meter deep for up to 30 minutes.
Do not use your accessories (ex: charger) near water (for example, near a bathtub or a sink, in a wet basement, or near a swimming pool) or spill liquid of any kind on your device or accessories as this might cause a short circuit, a fire, or an electric shock which could cause serious injury, death, and property loss.
Do not use your device in the resence of gas fumes as it presents a risk of fire or explosion.
Do not use or store your device in extreme temperatures as your device might overheat and may present a burn and fire risk and cease to function.
Do not dispose of your device in a fire as this might cause an explosion resulting in serious injury, death, and property loss.
Do not dispose of your device in a fire as this might cause an explosion resulting in serious injury, death, and property loss.
Federal Aviation Administration (FAA) and Federal Communications Commission (FCC) regulations prohibit using the radio of wireless devices while in the air. Turn off all wireless connections on your device before boarding an aircraft. Using your device on an aircraft might affect aircraft instrumentation, communication, and performance; might disrupt the network; might otherwise be dangerous to the operation of the aircraft, its crew, and its passengers; and might be illegal.
Do not disassemble your device. Your device contains small parts that might be a choking hazard.
Most modern electronic equipment is shielded from radio frequency (RF) signals. However, certain electronic equipment might not be shielded against the RF signals from your device. Keep your device away from medical devices, including pacemakers and hearing aids, as they might malfunction and cause serious injury or death to you and others.
Turn off all wireless connections on your device in health care facilities when any regulations posted in these areas instruct you to do so. Hospitals or health care facilities may be using equipment that could be sensitive to external RF energy.
Certain jurisdictions might prohibit or restrict your use of certain features on your device.

Additional Safety Guidelines About Charging

Use only the charger supplied with your device. The use of another type of charger will result in malfunction and/or danger.
Do not use the charger in a high-moisture environment. Never touch the charger when your hands or feet are wet.
Allow adequate ventilation around the charger when using it to operate the device or charge the battery. Do not cover the charger with paper or other objects that will reduce cooling. Do not use the charger while it is inside a carrying case.
Connect the charger to a proper power source. The voltage requirements are found on the product case and/or packaging.
Do not use the charger if the cord is damaged.
Do not attempt to service the unit. There are no serviceable parts inside. Replace the unit if it is damaged or exposed to excess moisture.

About the Battery

This unit contains a non-replaceable internal Lithium-Ion battery.
The battery can burst or explode, releasing hazardous chemicals.
To reduce the risk of fire or burns, do not disassemble, crush, puncture, or dispose of in fire or water.
Important instructions (for service personnel only) Caution: Risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
The battery must be recycled or disposed of properly.
Use the battery only in the specified equipment.

Caring for the Device

Taking good care of your device will ensure trouble-free operation and reduce the risk of damage to your device:

Keep your device away from excessive moisture and extreme temperatures.
Do not place anything on top of your device or drop objects on your device.
Do not drop your device or subject it to severe shock.
Do not subject your device to sudden and severe temperature changes. This could cause moisture condensation inside the unit, which could damage your device. In the event of moisture condensation, allow your device to dry out completely before use.
The screen surface can easily be scratched. Avoid touching it with sharp objects. Non-adhesive generic screen protectors designed specifically for use on portable devices with LCD panels may be used to help protect the screen from minor scratches.
Never clean your device when it is turned on. Use a soft, lint-free cloth to wipe the screen and the exterior of your device.
Do not use paper towels to clean the screen.
Never attempt to disassemble, repair or make any modifications to your device. Disassembly, modification or any attempt at repair could cause damage to your device and even bodily injury or property damage and will void any warranty.
Do not store or carry flammable liquids, gases or explosive materials in the same compartment as your device, its parts or accessories.
Do not expose your device to extreme heat or direct sunlight for prolonged periods. Overheating may damage your device.
Do not use alcohol or any abrasive material when cleaning the accessories.
Do not expose the accessories to extreme heat or direct sunlight for prolonged periods.
Store the accessories in a cool and dry place.

Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

FCC Caution

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The antenna(s) used for this transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. Operations in the 5.15-5.25GHz band are restricted to indoor usage only. FOR PORTABLE DEVICE USAGE (<20cm from body/SAR needed)
Note: The country code selection is for non-US models only and is not available to all US models. Per FCC regulation, all Wi-Fi products marketed in US must fixed to US operation channels only.

RF Exposure Information (SAR)

This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate or SAR. The SAR limit set by the FCC is 4.0W/kg (Head 1g SAR 1.6W/kg). Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value.
This is because the device is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. The highest SAR value for the model device as reported to the FCC when tested is 1.21 W/kg as described in this user guide (head 1g SAR 1.09W/kg). While there may be differences between the SAR levels of various devices and at various positions, they all meet the government requirements.
The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model device is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid.
For body-worn operation, this device has been tested and meets the FCC RF exposure guidelines for use with an accessory that contains no metal and be positioned a minimum of 10mm from the body. Use of other accessories may not ensure compliance with FCC RF exposure guidelines.
§15.19 (a)(3)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
§15.21
Changes or modifications not expressly approved by the party responsible for compliance could void the user`s authority to operate the equipment.
WEEE
This device must not be disposed of as normal household waste, in accordance with the EU directive for waste electrical and electronic equipment (WEEE – 2002/96/EC). Instead, it should be disposed of by returning it to the point of sale, or to a municipal recycling collection point.

Warranty Information

Warranty Period
The manufacturer warrants this device be free from defects in material and workmanship under normal use and service for twelve (12) months commencing upon the date of purchase by the first consumer purchaser. If proof of purchase cannot be provided, the manufacture date as recorded by the manufacturer based upon the serial number will be deemed to be the start of the Warranty Period.

Limited Warranty Statement

The consumer should never attempt to open or disassemble the device and doing so may cause damage that voids your warranty. The device is equipped with an internal rechargeable battery that is non-removable. This warranty does not cover defects

Resulting from improper or unreasonable use or maintenance.
Failure to follow operating instructions; accident; excess moisture; insects; lightning; power surges; connections to the improper voltage supply.
Unauthorized alteration or modification of original condition.
Damages caused by inadequate packing or shipping procedures.
Devices purchased from unauthorized dealers.

During the warranty period, the manufacturer will, at its sole option and as the customer’s sole remedy, therefore, (using new or refurbished parts), repair or replace any defective devices.
Repaired devices will be warranted for a period equal to the remainder of the original Limited Warranty on the original device or for NINETY (90) days, whichever is longer. All replaced parts, components, boards, and equipment shall become the property of the manufacturer. The warranty is good only to the original purchaser of the device during the warranty period as long as it is in the U.S.
Disclaimer of Warranties; Exclusion of Liability
Except as set forth in the express warranty contained above, the purchaser takes the device “AS IS”, and the manufacturer makes no express or implied warranty of any kind whatsoever with respect to the product, including but not limited to the merchantability of the product or its fitness for any particular purpose or use; the design, condition or quality of the device; the performance of the product; the workmanship of the product or the components contained therein; or compliance of the product with the requirements of any law, rule, specification or contract pertaining thereto.
In addition, the manufacturer shall not be liable for any damages of any kind resulting from the purchase or use of the device or arising from the breach of the express warranty, including incidental, special or consequential damages, or loss of anticipated profits or benefits. The manufacturer is not liable for performance issues or incompatibilities caused by your editing of registry settings, or your modification of operating system software. Using custom operating system software may cause your device and applications to work improperly.
Your carrier may not permit users to download certain software, such as custom OS. If your carrier prohibits this, if you attempt to download software onto the device without authorization, you will be notified on the screen that the device will no longer operate and be instructed to power down the device. You must then contact your carrier to restore the device to the carrier authorized settings.
Contact Verizon Customer Service at 800-922-0204
IEEE 1725 Battery Safety Statement

Do not disassemble or open, crush, bend or deform, puncture or shred.
Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose to water or other liquids, or expose the battery to fire, explosion or another hazard.
Only use the battery with a charging system that has been qualified with the system per CTIA Certification Requirements for Battery System Compliance to IEEE 1725. The use of an unqualified battery or charger may present a risk of fire, explosion, leakage, or another hazard.
Replace the battery only with another battery that has been qualified with the system per this standard, IEEE-Std-1725. The use of an unqualified battery may present a risk of fire, explosion, leakage or another hazard. Only authorized service providers shall replace batteries.
Promptly dispose of used batteries in accordance with local regulations.
Avoid dropping the Wearable Product. If the Wearable Product is dropped, especially on a hard surface, and the user suspects damage, take it to a service center for inspection.
Improper battery use may result in a fire, explosion or another hazard. For Wearable products that utilize a USB port as a charging source, the Wear- able’s user manual shall include a statement that the wearable shall only be connected to CTIA certified adapters, products that bear the USB-IF logo or products that have completed the USB-IF compliance program.
The Wearable product, including the power supply, should not be left in the rain or subjected to exposure to water. If cleaning is necessary, do not immerse in water; wipe clean with a damp cloth.
The Wearable product, including the power supply, should not be dropped, crushed (stepped on), or otherwise abused.
The user should be careful with the interconnect cable (wiring) between the power supply (adapter) and the Wearable product, in particular, as a potential trip hazard.