Page 5 of 7
« Previous Next »
Maintain the Pet TurboEraser® Tool
- Twist gray collar counter-clockwise, until slot appears, then separate faceplate.
- Remove Brush Roll, Belt, and Paddle Wheel. Inspect for damages and replace if necessary.
- To reassemble, align two clips on each end of Paddle Wheel with Belt on and pop back into place. Place Brush Roll with Belt back in. Faceplate will not close properly if all parts are not aligned correctly.
Replace Brush and Belt
WARNING: To reduce the risk of electric shock, turn power switch off and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks.
- Unplug vacuum, turn over and unscrew six (6) Philips-head screws to remove the bottom cover. Lift brush straight out.
- Clean debris from Brush Roll. Inspect by placing on its end and spin. The Brush Roll should spin freely, multiple times by one flick. If it doesn’t, replace Brush Roll. Check Belt for wear or cuts and replace if necessary.
- Replace the Brush Roll and Belt by looping the Belt over the motor shaft and the Brush Roll. Line up the end caps and pull the brush forward into place. This will stretch the belt. Return bottom cover back on and replace the screws.
Page 5 of 7
« Previous Next »
[View Manual Contents]
