Black Decker Professional Power Station PPRH5B manual

QUICK START GUIDE
BLACK+DECKER
PPRH5B

THIS QUICK START GUIDE IS NOT A SUBSTITUTE FOR THE INSTRUCTION MANUAL. PLEASE REFER TO THE INSTRUCTION MANUAL AND YOUR VEHICLE’S USER’S MANUAL BEFORE USE.

IF YOU HAVE ANY QUESTIONS, CALL CUSTOMER SERVICE AT 1-877-571-2391

IMPORTANT CHARGING INSTRUCTIONS

1. Immediately charge this unit for a full 40 hours upon receipt. This unit’s internal battery is shipped in a partially charged state and must be fully charged before use.
2. Fully charge the unit immediately after purchase, every 30 days, and after each use. Lead-acid batteries can lose charge over time.
   Regular recharging can optimize performance and battery life.

REVERSE POLARITY ALARM

When battery clamps are connected in reverse polarity, an audible alarm (continuous beep) will sound and the LCD screen will display the Reverse Polarity Indicator icon (please see Instruction Manual for details). DO NOT activate the unit. If this happens carefully disconnect the clamps and re-connect with the proper polarity. Ensure that the grounded clamp has a firm and clean connection.

USING THE AIR COMPRESSOR
To protect from overheating DO NOT use the Air Compressor for longer than 10 continuous minutes. Allow the unit to cool for a full 30 minutes before attempting to use again. Note that your compressor will store your last PSI setting in memory, making it easier to regularly top off your vehicle’s tires.

AC POWER

1. Press the AC/USB Power button on the control panel.
2. Digital Display shows AC, indicating the AC Outlet is ready to use.
3. Plug the 120V plug of your tool or appliance into the 120V AC Outlet and operate normally.

12V DC POWER

1. Lift up the cover of the unit’s 12 volt DC outlet.
2. Insert the 12 volt DC plug from the appliance into the 12 volt accessory outlet on the unit. DO NOT EXCEED A 5 AMP LOAD.

USB POWER

The USB charging port is under the same protective cover as the 12 volt DC outlet. Refer to the Features section to locate. Press the AC/USB power power button to turn the USB port on. A beep will sound and the backlit LCD screen will continuously display the following:

The icon indicates that the USB port is ready to use.

© 2021 Baccus Global, LLC. BLACK+DECKER and the BLACK+DECKER Logo are trademarks of Stanley Black & Decker, Inc. or an affiliate thereof and are used under license. All rights reserved.