Electrolux 63010 Dishwasher Manual

Operating instructions – Dishwasher Electrolux ESL 63010

The Control Panel

Indicator lights

• End of cycle
  Illuminates when the washing programme has ended.
• Salt
  Refilling indicator light.
  Illuminates when the salt has run out.

Programme selection/cancel button
To select a washing programme press the button until the indicator light corresponding to the desired washing programme illuminates.
The end of cycle indicator light flashes.
Once the washing programme has been set, close the dishwasher’s door, the programme will start automatically.

Audible signals
The audible signals indicate which operations the dishwasher is performing.

• end of washing programme
• the setting of the water softener
• malfunction of the machine

Washing programmes

Starting a washing programme

1. Check that the baskets have been loaded correctly and the spray arms can rotate freely.
2. Set the washing programme by pressing the programme selection/cancel button until the indicator light corresponding to the desired washing programme illuminates. The end of cycle indicator light flashes.
3. Once the washing programme has been set, close the dishwasher’s door, the programme will start automatically.

To interrupt a washing programme in progress

1. Open the dishwasher’s door; the programme will stop.
2. Close the door; the programme will start from the point at which it was interrupted.

To cancel a washing programme in progress

1. Open the dishwasher’s door.
2. Press the programme selection/cancel button for about 3 seconds, until the indicator light of the running programme turns off and the end of cycle indicator light flashes. The machine has returned to setting mode and it is possible to select another washing programme.
   Interrupt or cancel a washing programme in progress only if it is absolutely necessary. NB Hot steam may escape when the door is opened.

End of the washing programme

1. The dishwasher will automatically stop.
2. An audible signal informs you of the end of the washing programme.
3. Open the dishwasher’s door, leave it ajar and wait a few minutes before removing the dishes.
4. The end of cycle indicator light is on. The indicator light of the programme just ended is on.
5. Switch off the dishwasher by pressing the On/Off button.

Unloading the dishwasher

1. Allow the dishes to cool down before removing from the appliance.
2. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.
3. Water may appear on the sides and door of the dishwasher as the stainless steel will eventually become cooler than the dishes.