Electrolux Wet & Dry Vacuum Cleaner Z823 Manual

Instruction Book
WET & DRY VACUUM CLEANER FLEXIO POWER CLEAN Z823 /PENGHISAP DEBU

Product and Accessories

CLEANING TOOLS

Wet Nozzle
Plastic Tubes
Flexible Hose
Tools on Board
On/Off Switch
Power Plug
Clasp
Wheel
Exhaust Grille
Drum

Line drawings are solely for illustration purposes and are subject to variations from actual product.

Dear Customers,
Dear Customer, please read through these operating instructions carefully. Above all, please observe the safety instructions on the first few pages of this booklet. Please keep these operating instructions for future reference and pass them on to any subsequent owner of this appliance.

The safety standards of Electrolux electrical appliances are in keeping with the recognised rules of technology and the laws governing the safety of appliances. Prior to operating this appliance please familiarise yourself with the following safety instructions :

SAFETY INSTRUCTIONS

Read all the instructions and only use the appliance for its intended purpose.
The appliance must be switched off before plugging or unplugging it from the wall socket. Do not pull on the electrical cord to remove the plug from the wall socket.
Always remove the plug from the wall socket before attempting any form of user maintenance or cleaning, as specified in this booklet.
Do not handle the plug with wet hands.
Do not operate the appliance with a damaged electrical cord or plug. If the electrical cord is damaged it must be replaced by returning the product to an authorised Electrolux service centre or similar qualified person to avoid a hazard.
If the appliance has malfunctioned or been damaged in any manner return the appliance to the nearest authorised Electrolux service centre for examination, repair or adjustment.
Do not carry or drag the appliance by the electrical cord.
Keep the electrical cord away from heat, oil, sharp edges and rough or hot surfaces and do not run the appliance over the cord.
Hold onto the plug when rewinding the electrical cord to prevent the plug from whipping or hitting hard against the appliance.
An extension electrical cord may be used provided that it has a higher rating than the appliance. Please refer to the information provided on the appliance’s rating plate or consult your nearest authorized Electrolux service centre.
To protect against electric shock do not immerse the electrical cord, plug or the appliance in water or other liquids.
Do not expose the appliance to rain.
Do not use the appliance outdoors.
Never leave the appliance running unattended.
This appliance is not intended for use by person (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
Store the appliance away from high heat sources.
Do not use this appliance to vacuum up the following : – Inflammable or combustible substances, – Hard pointed objects, – Hot ash, lighted cigarette ends or anything that is burning or smoking. Large quantities of fine dust e.g. lime, cement or plaster dust, toner dust from laser printers etc.
Do not operate this appliance in areas where the substances listed above may be present.
To prevent the reduction in air flow, ensure that all orifices/vents on this appliance are kept free from blockages and do not insert any objects into these orifices/vents.
Do not use without filters in place.
If the motor overheats, it will turn off automatically. If this occurs, press the on off button and wait for a few minutes before switching on again.
Extra care should be taken when vacuuming staircases.
It is dangerous to alter the specifications or modify the vacuum cleaner, only use accessories recommended by Electrolux.
Under no circumstances should the customer attempt to repair the vacuum cleaner.
The vacuum cleaner should only be repaired and/or serviced by an authorized Electrolux service centre and only genuine Electrolux spare parts should be used. Failure to do so may render the warranty void.

This vacuum cleaner is for household use only.
Important ! This vacuum cleaner must only be connected to a power supply whose voltage and frequency comply with the specifications given on the appliance rating plate.

Quick Guide

When taking the product out of its packaging, check for damages.
VACUUM CLEANER ASSEMBLING
Always remove the plug from the power supply before fitting or removing accessories.
Before putting the appliance into the service, please check if all filters are inserted correctly.

Connecting vacuum cleaner
Fitting or removing the flexible hose to the air inlet A

Fit the flexible hose into the air inlet. Turn the hose grip clockwise until it clicks into position.
To release, first remove the plug from the power socket. Detach the flexible hose firmly from the air intake duct by turning anti-clockwise.

Fitting or removing the flexible hose to the air outlet B

Remove the exhaust grille and the filter.
Fit the flexible hose into the air outlet. Turn the hose grip clockwise until it clicks into position.
To release, first remove the plug from the power socket. Detach the flexible hose firmly from the air outlet duct by turning anti-clockwise.

Fitting the extension tubes and accessories

Fit the extension tube to the handle.
Fit the brush to the extension tube.

Fitting a chosen nozzle

Floor brush is intended for cleaning hard floors and carpets.
Crevice nozzle is for cleaning corners and cushions.
Use the wet nozzle only for cleaning wet surfaces.

Instructions for Use

CLEANING TOOLS
The crevice tool and dusting brush are stored on the accessories holder.

Floor Brush
Ideal for the daily cleaning on carpets and hard floors.

For the carpet
For the hard floor
Wet Nozzle
Ideal for absorbing water or liquid.
Wet nozzle to absorb water

Crevice Nozzle

The crevice nozzle can be used for cleaning corners, between cushions or difficult to reach places.

Dusting Brush

Dusting brush is used for the furniture, venation, blinds, books, lamp shades and shelves.

Operating Procedure

Before using the appliance, insert the plug into the power supply.
Press the On/Off button to switch the unit on. To stop it, press the On/ Off button again.
Always operate the cleaner with filter installed. Undo the clasp and remove the top cover from the body. Secure the filter in its position by pushing down the filter frame in its slot.

VACUUMING DUST

Before vacuuming dust, please make sure the body, motor housing, filter and attachments are dry.
Fit in the floor brush or other tools to vacuum the dust.

ABSORBING WATER

You may fit in the wet nozzle or other cleaning tools.
The safety buoy will not work when the body is filled with liquid. Please switch off the unit and remove the top cover. Pour out the liquid.
If the appliance has fallen over, water may enter into the motor. Ensure that there is no water inside the motor before operating again.

BLOWING DUST

Remove the filter grille from the blower position.
Fit the hose connection.
Once complete, remove the hose connection, fit the exhaust grille to its position turn/close tightly.

Note: If suction power of the vacuum cleaner gets weak during operation, kindly turn off the unit for a moment before resuming. If it still does not work, clean the body and take out the dust from the bin after turning off the unit. Continuous extended use of appliance and full dust bin may increase the motor temperature and may damage the unit.

Maintenance

DUST FILTER REPLACEMENT
Note:
Before doing any type of cleaning or maintenance to the cleaner, always ensure that the cleaner is unplugged from the wall socket.

After detaching the flexible tube, remove the top cover .
Lift up the dust filter to remove from its slot.
When suction is extremely low with a washed filter, replace with a new one. Filter life time may vary due to the usage. Contact Electrolux service station for the purchase of new filters.
Replace the top cover and secure both latches on each sides.

CLEANING FILTER

Note:

Filter must be cleaned when it becomes visibly solid.
Disconnect from electrical outlet before cleaning filters.
Do not use a washing machine to rinse filters.
Do not use hair dryer to dry filters.

Remove filter
Rinse filter in lukewarm water and dry the filter completely
Assemble back the filter

How To Store Your Vacuum

Choose a storage location that is both safe and dry.
The vacuum comes with an onboard tool coupling for storing the floor nozzle, slide the parking clip onto the parking positions on the cleaner.
Keep the extension tubes, nozzles and hose together to avoid losing them.

TROUBLESHOOTING

In case of malfunction, check for the following probable reasons. Make the necessary corrections which may be performed at home. If the problem persists, consult the Electrolux Authorized Service Centre.

PROBLEM	POSSIBLE CAUSES	CORRECTIONS
The vacuum cleaner does not start.	The plug is not properly connected to the socket. Thermal protector activated due to motor high temperature.	Check the plug connection or try another socket. Press the ON/OFF button and wait 30 minutes for the motor to cool off.
Reduction of suction capacity.	Suction hose blocked. Nozzle blocked. Filters clogged. Damaged or broken hose.	Clean the hose. Clean the nozzle. Clean or replace filters. Replace the hose.
Over heating.	Filters are clogged.	Clean /replace filters.