FANATEC ClubSport Pedais V3 Brake Performance Kit Manual

FANATEC ClubSport Pedais V3 Brake Performance Kit User Guide

HARDNESS COMPARISON

There are many possible combinations of Elastomer springs (A) – (D). This comparison table may give you a better idea of the effects when combining the different Elastomer springs:

PACKAGE CONTENT

• 2x Elastomer spring red Ø13 x 20 mm (A)
• 1x Elastomer spring red Ø12 x 20 mm (B)
  
• 2x Elastomer spring green Ø13 x 20 mm (C)
• 1x Elastomer spring green Ø12 x 20 mm (D)
  
• 1x Polyurethane spring (PU foam) Ø13,5 x 15 mm (E)
  
• 1x Lithium grease (F)
  
• 1x Installation tool (Fix-1) (G)
  

NOTE:
Required tools are not included in package content

MANUAL

IMPORTANT:

We strongly recommend reading the more detailed description about the Club Sport Pedals V3 Damper Kit inside the Club Sport Pedals V3 user manual! This contains important notes and more detailed instructions to avoid damages and achieve the best performance.
For detailed information please download the manual from www.fanatec.com/support. This is just a Quick Guide and you will miss a lot of features if you don’t read the manual.

ASSEMBLY

IMPORTANT: Please follow these steps carefully to avoid damages due to assembly mistakes which cannot be covered by warranty.

1. Turn the brake preload screw to backside end position (lowest preload).
   
2. To avoid pinching the vibration motor cable, insert the included installation tool (Fix-1) ‘behind’ the brake assembly.
   
3. Loosen the small screw (a) with Allen Key 2,5 mm, then remove the thin bolt (b) from the brake pedal lever.
   
4. Disconnect the load cell cable from ‘Brake’ port at the mainboard and take it out of the cable clips. Then turn the brake assembly downwards out from the brake pedal lever.
   
   IMPORTANT: Take care of the cables to avoid damages!
5. Remove the brake pedal bolt.
   
6. Remove the original Polyurethane springs and store them safely and light-protected for later use.
   
7. Insert the small Polyurethane spring (E) from Brake Performance Kit package content into the preload screw:
   
8. Select two pieces of the Elastomer springs (A) – (D) from Brake Performance Kit package content according to your preferences (refer to ‘hardness comparison’ of this Quick Guide) and apply Lithium grease (F) to their surface.
   
9. Insert the selected two pieces of the Elastomer springs (A) – (D) into the preload screw.
   
10. Insert the brake pedal bolt into the preload screw.
    
11. Turn back the brake assembly into the brake pedal lever (using the installation tool again), then reconnect the load cell cable to the ‘Brake’ port.
    
    IMPORTANT: Take care of the cables to avoid damages
12. Insert the thin bolt (a) into the brake pedal lever through the black block at the brake bolt, then tighten the small screw (b) with Allen Key 2,5 mm with moderate force again.
    
13. Adjust the preload screw so that the scale is within the correct use range and there is no mechanical  play in brake pedal. Note: Preload screw cannot be used in the full range as before, its use is limited only to eliminate the mechanical play.
    
    • Minimum preload setting for brake pedal.
      
    • Maximum preload setting for brake pedal.
      

Club Sport QR Code Scan Here

www.fanatec.com