Panasonic NN-TK81KC 24-Inch Microwave Trim Kit Manual

Installation Instructions

Cabinet	Trim kit
24″ (596 mm) 24 po (596 mm)	NN-TK81KC

Read carefully and keep these installation instructions.

CAUTION – Read and follow all instructions completely

This Trim Kit is designed for use only with the Panasonic Microwave Oven listed in the table below, for installation into a cabinet.
The dimensions and ground clearance of the cabinet opening must be as indicated in Figure 1 on pages 6-8.
For safe use of your microwave oven, do not alter or modify any part of this kit or the microwave oven.
The microwave oven must be used with a properly grounded 3-prong receptacle in compliance with the National Electrical Code, as well as any applicable local regulations. Refer also to the microwave operating instructions for other safety and electrical requirements.
The microwave oven must be unplugged from the wall receptacle before attempting the installation of this kit.
Save these instructions for local inspection and relocation of the microwave oven.
Use caution so that the power cord is not pinched during installation.
The diagrams in these instructions may vary from the actual unit and is only for reference.

Trim kit	Panasonic Microwave Oven Models
NN-TK81KC	NN-CD87KS

Parts List

Tools Needed: Measuring tape, pencil, Phillips screwdriver, Ø 2 mm ( 5 /64 ” ) drill

Parts Supplied

PART		QUANTITY
	Trim Frame	1
	Upper Duct	1
	Base Bracket Assembly	1
	Left Duct	1
	Bracket	4
	Catch	4
	Screw	12
	Strike	4
	long Tape	2
	Short Tape	2

Installation Diagram

Trim Kit Dimensions
Width	596 mm (23 ½”)
Height	410 mm (16 ⅛”)
Depth (Thickness)	20 mm (¾”)

Cabinet Diagram and Dimensions

Microwave Oven Preparation

Put 2 pieces of short tape and one piece of long tape on the top of the oven and put another piece of long tape on the left of the oven and left duct.

Lower Duct Installation

5-1. Aligning the base bracket assembly Position Base Bracket Assembly on the cabinet shelf. The left side of the Base Bracket Assembly should align flush with the left edge of the shelf. The front end of the Base Bracket Assembly should align flush with the front edge of the shelf.

5-2. Attaching the base bracket assembly