Schlage Keyless Touchscreen Deadbolt BE375 Manual

Instructions Instructions

Schlage Keyless Touchscreen Deadbolt [BE375]

Keyless Touchscreen Deadbolt

Prepare for Installation

Tools Needed

Phillips screwdriver
Tape Measure
Pencil

Optional

Flathead Screwdriver
Wood Block
Hammer

IMPORTANT NOTES

DO NOT use a power drill for installation!

Install and test lock with door open to avoid being locked out.
If tailpiece is not installed, insert into slot on the back of the touchscreen and snap into place.

A Check door dimensions.

See consumer.schlage.com/Service-Support for door preparation instructions if dimensions are different.

B Adjust bolt length, if necessary.

Measure the dimension shown. If the measurement is 2Cv” (70 mm), extend the bolt.

C Change faceplate, if necessary.

Choose the drawing that matches your door edge.

Install Lock

1. Install the bolt.

2. Install the touchscreen on the outside of the door.

Slide tailpiece through the slot in the bolt, and route wire over bolt.

3. Install the thumbturn assembly.

3a Rotate the thumbturn to a vertical position.

3b Remove the battery cover.

3c Route battery cable from the touchscreen through the hole in the thumbturn assembly.

3d Place thumbturn assembly against the door and secure with two (2) screws.

3e Connect the wires.

4 Install the included battery.

IMPORTANT
Route the battery wire so it won’t be pinched by the cover!

4a Install the battery cover. Do not pinch the wires!

5 Install reinforcement plate and strike into door jamb.

Test Lock

A. Extend the bolt (lock).

Did bolt extend?

B. Retract the bolt (unlock).

IMPORTANT
Press Schlage and rotate thumbturn away from the door edge. If the bolt retracts, the lock is not installed correctly. Pay attention to step 3a and try again.

Did bolt retract?

Program Lock

See the Schlage Touch™ User Guide that came with this lock. Go to schlage.com for videos and more. Register your product at RegisterMySchlage.com.

Lifetime Limited Mechanical and Finish Warranty and 3-Year Limited Electronics
Warranty
Subject to the terms and conditions of this warranty, Schlage extends a lifetime limited
mechanical and finish warranty and a three-year limited electronics warranty to the original
consumer user (“Original User”) of our Schlage brand product (“Product”) against defects in
material and workmanship, as long as the Original User occupies the residential premises upon
which the Product was originally installed.

What Schlage will do: Upon return of the defective Product to Schlage, Schlage’s sole
obligation, at its option, is to either repair or replace the Product, or refund the original purchase
price in exchange for the Product.

Original User: This warranty only applies to the Original User of Products. This warranty is not
transferable.

What is not covered: The following costs, expenses and damages are not covered by the provisions of this limited Warranty: (i) labor costs including, but not limited to, such costs as the removal and reinstallation of Product; (ii) shipping and freight expenses required to return Product to Schlage; and (iii) any other incidental, consequential, indirect, special and/ or punitive damages, whether based on contract, warranty, tort (including, but not limited to, strict liability or negligence), patent infringement, or otherwise, even if advised of the possibility of such damages. Some local laws do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion or limitation may not apply to you.

The provisions of this warranty do not apply to Products: (i) used in commercial applications; (ii) used in common area applications; (iii) used for purposes for which they
are not designed or intended; (iv) which have been subjected to alteration, abuse, misuse,
negligence or accident; (v) which have been improperly stored, installed, maintained or
operated; (vi) which have been used in violation of written instructions provided by Schlage;
(vii) which have been subjected to improper temperature, humidity or other environmental
conditions; or (viii) which, based on Schlage’s examination, do not disclose to Schlage’s
satisfaction non- an implied warranty lasts, so that the above limitations may not fully apply.
Refer to your local laws for your specific rights under this warranty.

Guaranteed Fit Program: Schlage products are designed to fit standard residential door preparations and retrofit existing tubular locks. Note: Mortise locks and preparations are not
considered standard and are not guaranteed under this program.

During the initial installation, if there is a problem with the Product’s performance, the Original
User may simply contact Schlage Customer Service at 888-805-9837 in the U.S. and Canada or 800-506-7866 in Mexico for assistance.Program and warranty claims: If you encounter a residential door preparation or fit issue under the Guaranteed Fit Program or have a claim under
this warranty, please contact Schlage Customer Service for repair, replacement or refund of the
original purchase price in exchange for the return of the Product to Schlage.

Schlage Customer Service
Calling From:
U.S.A.: (888) 805-9837
Canada: (800) 997-4734
Mexico: 018005067866