WALI Monitor Desk Stand GPV001 Manual

INSTALLATION MANUAL
Monitor Desk Stand
GPV001

www.walielectric.com 
 [email protected]
1-844-SATTLER (18447288537)

 WARNING
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect assembly, or inappropriate use.

TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF THE MONITOR OR STAND.
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.

THE USE OF TIP-OVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE THE RISK OF TIP-OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.

Supplied Parts List

1. Connect Pole A and BaseB using Bolt E and tighten with Allen Key 4mm G.
   
2. Tear off the protective paper to attach Anti-Skid Pad F to the bottom designated position of Base B as image shown.
   

Step 3.1 : Select TV Screws
Only one screw size fits your TV
Step 3.2
Select Spacers ( if needed )
Step 3.3a
Flat Back Monitor
Select M4x12 Bolt M-A or M5x12 Bolt M-C according to your TV/Monitor, connect VESA Plate E together with D5 Washer M-E into the mounting holes on the back of  TV/Monitor, tighten with a screwdriver. (Screwdriver not included)
Step 3.3b
Curved Back Monitor
Select M4x16 Bolt M-B or M5x16 Bolt M-D according to your TV/Monitor, connect VESA Plate E together with D5 Washer M-E and Spacer M-F into the mounting holes on the back of the TV/Monitor, tighten with a screwdriver. (Screwdriver not included)

4. Put the assembled TV/ Monitor onto the Pole A and tighten the VESA Plate with Bolt D for stability.

5. Adjust the tilt angle using Allen Key 6mm H .

6. Tear off the warning label from the gas spring button. Keep your hand pressing on the top of Pole A to prevent it pops up. Open up the button and adjust the Pole A to the personally preferred height. Lock the button and ensure stability. Suggest standing for easier adjustment.

7. Guide the cable through the clip holder and store the Allen Keys G H in the holder.

8. Manually swivel, tilt or rotate the monitor for the best viewing angle.