waterpik Shower Head Manual

waterpik Shower Head Instruction Manual

Introduction

Thank you for purchasing this Waterpik® shower head. This booklet provides information to make installation easy and quick. You are close to enjoying a powerful and invigorating shower experience with your new Waterpik® shower head.
You can view more information about Waterpik® shower head products at www.waterpik.com. To learn more about Waterpik® water for wellness® benefits go to www.waterpikwellness.com.
Note: Pictures shown may not directly match your shower head.

PRIOR TO INSTALLATION

Remove old shower head and remove all pipe tape.
Ensure that the washer from the old shower is not connected to the shower pipe. Use a thin utensil to check inside the shower pipe for washers, such as a pencil or screw driver. Do not use your fingers.
Gather the tools necessary to install your new shower head

TOOLS YOU MAY NEED

Tools may be needed for removal of old shower head or tightening new shower head.
Adjustable Wrench or Pliers (not included).
Soft Cloth (not included).
Pipe tape is not recommended.

Hand Held Shower Head

Tighten pivot ball to pipe by turning in a clockwise direction as shown. Ensure large nut is secure by hand tightening.
Connect either end of the hose to the bottom of the bracket by turning clockwise. Hand tighten. (See note below).
Connect other end of hose to hand held shower head and hand tighten.
Place hand held shower head in bracket.

Vacuum Breaker Backflow Prevention
Note: Several U.S. state and local municipal plumbing codes require the use of a backflow prevention device when installing a hand shower. This device is termed a vacuum breaker. If your hand shower includes a vacuum breaker it will be located in the hose, and the hose end with the vacuum breaker will include a sticker that reads “attach this vacuum breaker end to shower bracket.” If the hose is not installed in this manner, water will not flow. If your hand shower does not include a vacuum breaker, and you would like to obtain one free of charge, please contact us at 1-800-525-2774 (U.S. calls only) and request part number 20009558.

OPERATION

Spray Selector:
Spray Selector allows you to select from various spray patterns. Spray pattern is controlled by the small lever that rotates left and right. Rotate the face of the shower head to change settings.

SPECIAL FEATURES

Align the spray selector with the handle to activate the PowerComb® spray. PowerComb is a natural water comb that penetrates deep to the roots of the hair for a thorough rinse and scalp massage.
Move the tab to the left for SoftComb™ spray, a softer blanket of sweeping water for gentler rinsing.

WARNINGS:

To avoid hot water dangers and conserve even more energy, make sure your water heater is set at 120°F (48.9°C) or below.
Test the tub/shower water with your hand before bathing.
For additional safety for Ecoflow® or high efficiency shower heads, it is recommended that all homes have installed a pressure balance tub and shower valve with the rotational limit stops properly set by a plumber. If you are unsure of your valve type consult your plumber.
For external use only. The potentially deadly amoeba, Naegleria fowler, may be present in some tap water or unchlorinated well water.
Always ensure the hand held shower head is properly placed in the bracket, so as to prevent the shower head from falling.
Do not pull on or tug the flexible hose. This may result in the shower head coming loose and falling.

CARE AND CLEANING

To maintain proper working conditions cleaning is required when mineral deposits appear on the spray orifices. To clean mineral deposits, gently rub the rubber nozzles on the face of the shower head to dislodge.
To clean heavier deposits, remove shower head and soak face down in 1-2 cups of white vinegar (use white vinegar only) for about 2-3 hours. Replace shower head and run in each mode to flush out vinegar. Repeat as necessary.
Do not clean or rinse any part with harsh chemicals, heavy duty cleaners, or abrasives; this may damage parts or finish and will void warranty.
Clean filter screen by unscrewing from the pivot ball and rinse by back flushing to remove particles. Follow steps 1-3 under installation to reinstall shower head, making sure washer is re-seated on top of filter screen.

TROUBLESHOOTING GUIDE

Problem	Solution
No water flow from installed shower head.	Confirm previous shower washer is not in the shower pipe. Confirm there is only one washer in the pivot ball.
Low water pressure or missing spray patterns.	Clean shower head in vinegar/water solution. (See care & cleaning section). Clean filter screen.
Leaking at pipe/pivot ball connection.	Confirm only one washer is seated on top of the screen. Grate bar of soap across the shower pipe threads to act as a sealant. Make sure all pipe tape is removed from shower pipe. Please refer back to installation instructions for pipe tape.
Bracket is too stiff to change angle.	Install hand held in bracket (as shown in Step 4) to provide additional leverage to change angle of spray (contact Water Pik for further instructions).
Leaking at hose connection to shower head or shower head bracket.	Make sure rubber washer is in place inside hose connector.

LIFETIME LIMITED WARRANTY

Save your receipt as proof of purchase is required for warranty action. Water Pik, Inc. warrants to the original purchaser of this product that it is free from defects in material and workmanship for as long as the original purchaser owns this product. Water Pik, Inc. will replace the product which in our opinion is defective, provided that the product has not been abused, misused, altered or damaged after purchase. (This includes damage due to use of tools or harsh chemicals.) In the event an item has been discontinued we will replace with what we deem to be the closest product. Water Pik, Inc. is not responsible for labor charges, installation, or other consequential cost. The responsibility of Water Pik, Inc. shall not exceed the original purchase price of the product. This warranty gives you specific legal rights. You may also have other rights that vary where you reside.
Water Pik disclaims all other express or implied warranties to the extent permitted by law including, but not limited to, all warranties of merchantability and fitness for a particular purpose. All implied warranties are limited to the duration of this limited warranty. Some states or provinces may not allow limitation on how long an implied warranty lasts, so above may not apply to you.

For USA Only
Limitation of Liability: This limited warranty is your sole remedy against Water Pik and it shall not be liable for any damages, whether direct, indirect, incidental, special, consequential, exemplary or otherwise, including but not limited to property damage, arising out of any theory of recovery, including statutory, contract or tort.

BINDING ARBITRATION AND WAIVER OF RIGHT TO ASSERT
MATTERS IN COURT AND RIGHT TO JURY TRIAL
By purchasing, installing, or using this product you agree that any controversy or claim arising out of or relating to your purchase, use, modification, installation, or removal of this product shall be settled by binding arbitration. The arbitrator’s decision will be final and binding. Judgment on the award rendered by the arbitrator may be entered in any court having jurisdiction over the matter. Further, you agree that you will not have the right to litigate any claim arising out of or in relation to our purchase, use, modification, installation, or removal of this product in any court or to have a jury trial on that claim.
Arbitration of any matters shall be administered by the American arbitration association and conducted by one arbitrator in accordance with the consumer arbitration rules of the American Arbitration Association in effect at the time of filing of the demand. The venue for all such arbitrations shall be Colorado and any such arbitration shall be subject to the Federal Arbitration Act and Colorado law.

WAIVER OF RIGHT TO PARTICIPATE IN CLASS ACTIONS OR
PURSUE CLAIMS IN A REPRESENTATIVE CAPACITY.
Further, by purchasing, installing, or using this product you agree that arbitration must be on an individual basis. This means neither you, nor we, may join or consolidate claims in arbitration by or against other purchasers or users of Water Pik products or the general public. Additionally, you may not litigate in court or arbitrate any claims as a representative or member of a class or in a purported representative capacity on behalf of the general public, other purchasers or users of this product, other persons or entities similarly situated, or in a private attorney general capacity.

If product malfunctions or becomes damaged, stop use and contact Water Pik, Inc. for assistance.

Have any questions or need assistance?

For quick service prior to calling have your model number and receipt ready.

In the U.S., call our toll-free In Canada, call our bilingual Customer Assistance Line toll-free Customer Assistance 1-800-525-2774, Monday – Line 1-888-226-3042, Monday – Friday, 7:00 AM – 5:00 PM MST. Friday, 7:00 AM – 5:00 PM MST.
English only. or visit www.waterpik.ca or visit www.waterpik.com © 2021 Water Pik, Inc.

Contact Us

Address: Water Pik, Inc., a subsidiary of Church & Dwight Co., Inc. 1730 East Prospect Road Fort Collins, CO
Phone: 80553-0001
Web: U.S.A. www.waterpik.com