SMI50C02GB Dishwasher
Instruction Manual
| 1. ON/OFF switch | 6. Timer programming * |
| 2. Door Opener | 7. Additional options ** |
| 3. Programme selector | 8. Rinse aid refill indicator |
| 4. START button | 9. Salt refill indicator |
| 5. Digital display | 10. Display “Check water supply” |
*Depending on model
**Number depending on model
Overview of Programmes
Select a suitable program according to the type of utensils and degree of soiling.
The maximum possible number of programs is illustrated in this overview: 
Additional Options
Additional options can be set with the buttons 7
Express Wash/Speed Perfect/(VarioSpeed)*
This function can reduce the running time by approx. 20-50% depending on the selected rinse program. The change in the running time is indicated on the digital display. To obtain optimum cleaning results at a reduced running time, water and energy consumption are increased.
Half Load *
If you have only a few items to wash you can switch to “half load”. This will save water, energy, and time. It is recommended to put a little less detergent in the detergent dispense than for a full load.
Hygiene *
The temperature is increased during the cleaning process. This increases the hygiene status. This additional option is ideal for cleaning e.g. chopping boards and baby bottles.
Intensive zone *
Perfect for a mixed load. You can wash very soiled pots and pans in the lower basket together with normally soiled utensils in the upper basket. The spray pressure in the lower basket is intensified, the rinsing temperature is increased slightly.
Extra drying *
An increased temperature during the final rinse and an extended drying phase ensures that even plastic parts dry better. There is a slight increase in energy consumption.
Switching on the appliance
- Switch the ON/OFF switch
- Rotate program selector to the required program. The expected program duration flashes on the digital display.
- Press the START button. The program starts running.
Remaining running time display
When the program is selected, the remaining running time of the program is indicated on the digital display.
The running time is determined during the program by the water temperature, the number of utensils, as well as the degree of soiling, which may vary depending on the selected program.
Timer programming *
You can delay the start of the program in 1-hour steps up to 24 hours.
- Close the door
- Switch the ON/OFF switch
- Press button 6 until the digital display jumps to
- Press button 6 until the displayed time corresponds with your requirements.
- Press the START button, timer programming is activated.
- To delete the preselected starting time, press button 6 until
is indicated on the digital display. - You can change your program selection at any time until the program starts.
End of program
The program has ended when the value
is indicated on the numerical display.
Switching off automatically after the end of the program *
*depending on model
To save energy, the dishwasher is switched off 1 minute after the program ends.
At the end of the program please open the door fully and not partially when emptying the dishwasher. Remove the utensils when they have cooled down.
Interrupting the program
- Switch off the ON/OFF switch, the LEDs go out. The program is saved.
- If the door was opened on an appliance that has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance.
- To continue the program, switch on the ON/OFF switch again.
