Bissell 1792 Series Powerlifter Rewind Vacuum User Guide
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM.
When using an electrical appliance, basic precautions should be observed, including the following:
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY:
» Always connect to a polarized outlet (one slot is wider than the other). Do not modify the polarized plug to fit a non-polarized outlet or extension cord.
» Do not leave vacuum cleaner when it is plugged in. Unplug from outlet when not in use and before servicing.
» Do not use outdoors or on wet surfaces.
» Do not allow to be used as a toy. Close attention is necessary when used by or near children.
» Do not use for any purpose other than described in this User’s Guide. Use only manufacturer’s recommended attachments.
» Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, have it repaired at an authorized service center.
» Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
» Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
» Do not handle plug or vacuum cleaner with wet hands.
» Do not put any object into openings. Do not use with any opening blocked; keep openings free of dust, lint, hair, and anything that may reduce air flow.
» Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
» Turn off all controls before plugging or unplugging vacuum cleaner.
» Use extra care when cleaning on stairs.
» Do not use to pick up flammable or combustible materials (lighter fluid, gasoline, kerosene, etc.) or use in areas where they may be present.
» Do not use vacuum cleaner in an enclosed space filled with vapors given off by oil base paint, paint thinner, some moth proofing substances, flammable dust, or other explosive or toxic vapors.
» Do not use to pick up toxic material (chlorine bleach, ammonia, drain cleaner, etc.).
» Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
» Do not use without filters in place.
» Do not pick up hard or sharp objects such as glass, nails, screws, coins, etc.
» Use only on dry, indoor surfaces.
» Keep appliance on a level surface.
» Do not carry the vacuum cleaner while it is running.
» Hold plug when rewinding into cord reel. Do no allow plug to whip when rewinding.
THIS APPLIANCE HAS A POLARIZED PLUG
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do not change the plug in any way.
Thanks for buying a BISSELL vacuum!
We love to clean and we’re excited to share one of our innovative products with you. We want to make sure your vacuum works as well as it does today for years to come, so this guide has tips on using (page 6-7), maintaining (pages 7-10), and if there is a problem, troubleshooting (page 10). Your vacuum needs a little assembly before you can put it to work, so flip to page 5 and let’s get started!
What’s in the Box
NOTE: Standard accessories may vary by model. To identify what should be included with
your purchase, please refer to the “Carton Contents” list located on the carton top flap.
NOTE: The Dusting Brush does not store on vacuum.
Getting to Know Your Vacuum
- Handle 10. Stretch Hose
- Dirt Tank Release Button 11. Power Cord
- Dirt Tank 12. Crevice Tool
- Hose Wand Base 13. Extension Wand
(remove to use tools) 14. Hose Clip - Pre-Motor Filter 15. Power Switch Pedal
(located under dirt tank) - Post Motor Filter Door Access 16. Handle Recline Pedal
- Height Adjustment Knob 17. Dusting Brush (does not store on vacuum)
- Triple Action™ Brush Roll
- Cord Rewind
Assembly
The only tool you will need to assemble your vacuum is a Phillips screwdriver
Slide handle down over body of vacuum.
Insert two screws and fasten using screwdriver.
Insert hose with elbow end facing down and align, locking tab with slot. Rotate clockwise
until snapped into place.
Take the opposite end of the hose and open the foot base door. Insert hose end into foot and
push into place. Once inserted into the foot, hose should be stretched into the side and upper hose clips.
Install extension wand and crevice tool in back of the unit as shown.
NOTE: The Dusting Brush does not store on-board (see Tools section for usage).
Tools
To attach any of the included tools, remove the lower wand base from the foot of the vacuum and from both hose
clips. Insert the desired tool firmly into the hose end.
Extension Wand Attach with desired tool for longer reach.
Dusting Brush Use brush to dust furniture, blinds, books, lamps, shelves and baseboards.
Crevice Tool Remove debris from crevices, furniture, and along baseboards of your home with the crevice tool.
NOTE: The Dusting Brush does not store on the vacuum.
Operations: Power On and Settings
To power ON, step on the RED Power Switch Pedal located near the bottom and center on the back side of the
unit. Push the lower Handle Recline Pedal two times for an even lower recline.
Turn dial on foot to adjust to 1 of 5 height adjustments.
Lowest Setting: For low pile carpet and bare floors. Medium Setting: For medium pile carpet. Highest Setting: For high pile and most shag carpet. Adjust to
high setting if difficult to push.
NOTE: For optimal cleaning, adjust to the lowest practical setting. If your vacuum is difficult to push, or is
pushing larger debris, adjust to the next higher setting.
Operations: Automatic Cord Rewind
Gently pull out power cord and stop when yellow band is visible on the cord. Do not pull power cord beyond the red
line. Plug cord into electrical outlet.
To return cord, turn vacuum power switch off and remove plug from outlet.
Hold plug and press automatic cord rewind button located on the lower side of the unit to wind cord into reel. Do not allow plug to whip when rewinding.
Maintenance: Empty Dirt Tank
Remove tank by pressing the release button on the tank handle.
Grasp handle on back of tank with one hand and the top handle with the other. Twist
the top handle counterclockwise until latches release. Pull the top handle straight up from the dirt tank.
Empty contents of dirt tank into trash container, and gently shake the top handle to remove build up
Place the top handle straight down into the dirt tank. Align the latch arrows and gently twist clockwise.
When fully assembled, the tank will click into place. Replace the tank back onto the vacuum – it will click when fully installed.
NOTE: If you notice excess build up around the top of the tank, before removing top piece, gently tap the tank to allow contents to settle.
Maintenance: Pre-Motor Filter
To reduce the risk of electrical shock, turn power switch OFF and disconnect polarized plug
from electrical outlet before performing maintenance or troubleshooting checks.
Remove the dirt tank to locate and remove the pre-motor filter. Pinch the filter and lift to remove from unit.
Wash the foam filter with water and light dish soap. Let dry completely before reinserting into your vacuum.
NOTE: Filter can be rinsed in warm water. Allow it to completely dry before replacing. If the filter is damaged, replace the part.
Maintenance: Post-Motor Filter
Located on the front near the height adjustment knob, remove filter door by pressing and pulling latch downward.
Remove the filter by grasping the handle on the front of the filter and pulling out from
vacuum. Tap out dust or replace filter as necessary.
Replace filter in unit with handle facing you. Replace the door by hooking the bottom into the grooves
and rotate towards unit, snapping into place.
NOTE: The pleated postmotor filter may NOT beb washed with water or detergent. If dust and/or debris accumulates on filter,
gently tap the filter on the ide of a garbage container
Do not operate vacuum with damp or wet filters, as well as without filters or the Dirt
Container in place. Allow components to dry before reassembling the Dirt Container.
Maintenance: Floor Brush Roll
Ensure vacuum is unplugged. Place handle in low position, remove hose from foot and turn vacuum over bottom side
up. Remove 6 screws with a Phillips head screwdriver. Lift brush cover off of the vacuum.
Grasp rotating floor brush at both ends and lift straight out of the vacuum foot. Slip off the belt.
Clean debris from rotating floor brush, motor pulley, drive belt and air passageway areas.
Maintenance: Drive Belt
With rotating brush removed (steps 1-3 maintenance floor brush roll), grasp old drive belt and remove from motor pulley.
Place new belt over motor pulley and stretch other end over the floor brush.
Place ends of rotating floor brush down into slots. Reposition bottom cocover and
replace all 6 screws.
Maintenance: Cleaning the Dirt Tank
With the top handle removed, wash the dirt tank in warm water with mild detergent. Allow tank to air dry
Twist top handle from the round separator counterclockwise to release. Wash in warm water with
mild detergent. Dry completely before reassembling.
Align tabs to return separator to top handle. Align latch arrows and twist tank clockwise
until “clicks” into place.
Maintenance: Clearing a Clog
Remove dirt tank and check suction inlet located on body of vacuum for debris.
Grasp upper hose end and twist elbow counterclockwise to remove. Remove lower hose end by pulling it from
vacuum base. Unclog by inserting a “blunt” object, like a broom handle, into hose to dislodge blockage. Do not use sharp objects.
NOTE: If clog persists, follow the floor brush roll maintenance steps on page 8 and inspect air passageways for obstructions.
Troubleshooting
Warranty
This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty
or have questions regarding what it may cover, please contact BISSELL Consumer Care by E-mail, telephone, or regular mailas described below.
Limited Six-Month Warranty
Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, upon receipt of the product BISSELL will repair or replace (with new or remanufactured components
or products), at BISSELL’s option, free of charge from the date of purchase by the original purchaser, for six months any defective or malfunctioning part. See information below on “If your BISSELL
product should require service”. This warranty applies to product used for personal, and not commercial or rental service. This warranty does not apply to fans or routine maintenance components
such as filters, belts, or brushes. Damage or malfunction caused by negligence, abuse, neglect, unauthorized repair, or any other use not in accordance with the User’s Guide is not covered.
BISSELL IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE ASSOCIATED WITH THE USE OF THIS PRODUCT. BISSELL’S LIABILITY WILL
NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
*EXCEPTIONS AND EXCLUSIONS FROM THE TERMS OF THE LIMITED WARRANTY
THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES EITHER ORAL OR WRITTEN. ANY IMPLIED WARRANTIES WHICH MAY ARISE
BY OPERATION OF LAW, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED
TO THE SIX MONTH DURATION FROM THE DATE OF PURCHASE AS DESCRIBED ABOVE.
Some states do not allow limitations on how long an implied warranty lasts so the above limitation may not apply to you.
NOTE: Please keep your original sales receipt. It provides proof of date of purchase in case you ever need to make a warranty claim.
If your BISSELL product should require service:
Contact BISSELL Consumer Care to locate a BISSELL Authorized Service Center in your area. If you need information about repairs or replacement parts, or if you have questions about
your warranty, contact BISSELL Consumer Care.
NOTE: Please keep your original sales receipt. It provides proof of purchase date in the event of a warranty claim. See Warranty on page 11
for details.
