Bissell 2258 Series Cleanview Swivel Rewind Pet
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM.
Always connect to a polarized outlet (one slot is wider than the other). Unplug from outlet when not in use and before conducting maintenance. When using an electrical appliance, basic precautions should be observed, including the following:
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
- Do not leave vacuum cleaner when it is plugged in. Unplug from outlet when not in use and before servicing.
- Do not use outdoors or on wet surfaces.
- Do not allow to be used as a toy. Close attention is necessary when used by or near children.
- Do not use for any purpose other than described in this User’s Guide. Use only manufacturer’s recommended attachments.
- Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, have it repaired at an authorized service center.
- Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
- Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
- Do not handle plug or vacuum cleaner with wet hands.
- Do not put any object into openings. Do not use with any opening blocked; keep openings free of dust, lint, hair, and anything that may reduce air flow.
- Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
- Turn off all controls before plugging or unplugging vacuum cleaner.
- Use extra care when cleaning on stairs.
- Do not use to pick up flammable or combustible materials (lighter fluid, gasoline, kerosene, etc.) or use in areas where they may be present.
- Do not use vacuum cleaner in an enclosed space filled with vapors given off by oil base paint, paint thinner, some moth-proofing substances, flammable dust, or other explosive or toxic vapors.
- Do not use to pick up toxic material (chlorine bleach, ammonia, drain cleaner, etc.).
- Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
- Do not use without filters in place.
- Do not pick up hard or sharp objects such as glass, nails, screws, coins, etc.
- Use only on dry, indoor surfaces.
- Keep appliance on a level surface.
- Do not carry the vacuum cleaner while it is running.
- Unplug before connecting or disconnecting the Pet TurboEraser® Tool.
SAVE THESE INSTRUCTIONS
WARNING
›› Before using your vacuum, make sure the Dirt Tank is in locked position and that all filters, both pre- and post-filters, are in place. DO NOT operate your vacuum without these filters.
›› Plastic film can be dangerous. To avoid danger of suffocation, keep away from children.
›› Do not plug in your vacuum UNTIL you are familiar with all instructions and operating procedures.
›› To reduce the risk of electrical shock, turn power switch off and disconnect polarized plug from electrical outlet BEFORE performing maintenance or troubleshooting checks.
THIS APPLIANCE HAS A POLARIZED PLUG
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do not change the plug in any way
What’s In The Box?
- Vacuum Base
- Handle
- Hose
- 2 Screws (taped to Handle)
- Extension Wand Base
- Extension Wand
- Crevice Tool (stored inside Extension Wand)
- Pet TurboEraser® Tool
- Dusting Brush
NOTE: Not all accessories come with every model. Be sure to check the carton for additional tools.
Product View
WARNING: Do not plug in your vacuum until you are familiar with all instructions and operating procedures
Assembly
The only tool you will need to assemble your vacuum is a Phillips-head screwdriver.
- Place the Upper Handle onto the base and push it down. Then attach the handle with the 2 screws taped to the handle in a plastic bag
- Insert the Extension Wand base and turn it to the right to lock in place.
- Insert the Stretch Hose end into the back of the vacuum and twist right to lock in place.
- Wrap Hose up and around the Hose Wrap on the handle. Slide end of hose into vacuum base.
Now, put your accessory tools on the vacuum and you’re ready to go! - Dusting Brush
- Pet TurboEraser® Tool
- Extension Wand (Crevice Tool stores inside
NOTE: The Powerfoot will not suction properly unless the hose is fi rmly attached
Power On and Settings
WARNING To reduce the risk of injury from moving parts while the vacuum is turned on, always move the vacuum via the rolling wheels by using the upper handle at the back of the vacuum. Do not carry the vacuum while it is running. Always place vacuum on floor with handle in upright position when using tools.
- Press the red power button with your foot to turn the vacuum ON and once again to turn your vacuum OFF.
- Press the recline pedal and pull handle back towards you.
- Turn the dial on the foot of the vacuum to the desired setting. If the dial is difficult to turn, tilt the vacuum back slightly to take the weight off the foot while turning
Lowest setting – For low pile carpet or bare floors. To pick up debris, it may be necessary to move up one setting.
Medium setting – For medium pile carpet.
Highest setting – For high pile and most shag carpet.
TIP: For optimal carpet cleaning performance, adjust to the lowest practical setting. If your vacuum is difficult to push, adjust to the next higher setting.
Automatic Cord Rewind
- To plug your vacuum in, gently pull the cord out of the automatic cord rewind and stop at the yellow mark on the cord. Do not pull past the red mark. Once you have the desired amount of cord, plug it into the outlet.
- When you finish using your vacuum, unplug it from the outlet. Hold onto the plug and press the automatic cord rewind button until it’s fully retracted. If the cord doesn’t fully retract on the first try, pull a little bit of cord out and press the rewind button again.
NOTE: Rotating Floor Brush continues to rotate while tools are in use. Never place fingers under the vacuum when it is running. Never place Powerfoot on furniture or uneven surfaces. Do not place vacuum close enough to objects to pull into rotating brush.
NOTE: Certain carpets and low humidity conditions may generate small static discharges. Static discharges are harmless and are not associated in any way with the main power supply.
Empty the Dirt Tank
WARNING: To reduce the risk of electric shock, turn power switch off and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.
- Empty once Dirt Tank is full
- Press the tank release button and pull out to remove Dirt Tank.
- Hold the Dirt Tank over a trash container. Press the bottom release button to empty. Once empty, close the lid.
- Twist Cyclone left and pull down to remove from tank
- Clean Cyclone with warm water and mild detergent. Let Cyclone dry completely before replacing. To replace, fit into place and twist to the right.
- After emptied, place tank back on vacuum and press firmly until you hear “click.”
NOTE: The Dirt Tank may be washed in warm water with a mild detergent. Make sure it is completely dry before replacing.
Clean the Pre-Motor Filter
WARNING: To reduce the risk of electric shock, turn power switch off and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks.
WARNING: Do not operate vacuum with damp or wet fi lters or without all filters in place
- Press the tank release button and pull out to remove Dirt Tank.
- Remove Carbon and Foam Filter from lid. Hand wash in warm water and rinse well; mild detergent may be used if desired.
- Allow filter to air dry completely before placing back into the tank lid. The Carbon Filter should be on top of the Foam Filter.
- Return tank back on vacuum and press firmly until you hear “click”.
Maintain the TurboEraser® Tool
- Twist gray collar counter clockwise, until slot appears, then separate faceplate.
- Remove Brush Roll, Belt, and Paddle Wheel. Inspect for damages and replace if necessary
- To reassemble, align two clips on each end of Paddle Wheel with Belt on and pop back into place. Place Brush Roll with belt back in. Faceplate will not close properly if all parts are not aligned correctly
Replace Brush and Belt
WARNING: To reduce the risk of electric shock, turn power switch off and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks
- Unplug vacuum, turn over and unscrew six (6) Phillips-head screws to remove the bottom cover. Lift brush straight out.
- Clean debris from Brush Roll. Inspect by placing on its end and spin. The Brush Roll should spin freely, multiple times by one flick. If it doesn’t, replace Brush Roll. Check Belt for wear or cuts and replace if necessary
- Replace the Brush Roll and Belt by looping the Belt over the motor shaft and the Brush Roll. Line up the End Caps and pull the brush forward into place. This will stretch the Belt. Return bottom cover back on and replace the screws.
Clearing a Clog
- Remove the Stretch Hose from the back of the vacuum by twisting it to the left. Remove any debris that may have gotten clogged.
- Check the Foot Hose onthe back of your vacuum down towards the bottom. If necessary, remove the screw from the Foot Hose and check for clogs.
- Check the air passageway on the bottom of your vacuum. Remove the bottom cover and the brush. Remove any debris.
Troubleshooting
Problem | Possible causes | Remedies |
Vacuum won’t turn on | Power cord not plugged in | Check electrical plug |
Blown fuse/tripped breaker | Check/replace fuse or reset breaker | |
Vacuum won’t pick up dirt | Incorrect height adjustment | Adjust Powerfoot to correct height setting |
Hose not attached to suction opening | Grasp the Hose Wand and firmly push into the Hose Wand Base | |
Crack or hole in Stretch Hose | Check Hose and replace if needed | |
Broken or worn Drive Belt | Replace Drive Belt | |
Rotating Floor Brush jammed | Remove brush and clean debris from brush ends. | |
Clog in vacuum | Check for debris build-up or clogs in the Inner Tank, Hose and Foot/Lower Hose; see online video for additional help | |
Dirt Tank is full | Empty Dirt Tank | |
Dirt Tank is not installed properly | Position correctly and lock in place. | |
Filters are dirty | Check and clean or replace pre-motor and post-motor filters. | |
Tool won’t pick up |
Crack or hole in Stretch Hose | Check Hose and replace if needed |
Clog in vacuum | Check for debris build-up or clogs in the Inner Tank, Hose and Foot/Lower Hose; see online video for additional help | |
Dirt Tank is full | Empty Dirt Tank | |
Dirt Tank not installed properly | Position correctly and lock in place. | |
Filters are dirty | Check and clean or replace pre-motor and post-motor filters. | |
Vacuum difficult to push | Incorrect height adjustment | Adjust Powerfoot to correct height setting. |
Visible dirt escaping from vacuum | Dirt Tank is full | Empty Dirt Tank |
Filters missing or installed incorrectly | Check pre-motor and post-motor filters for correct installation. |
Parts & Supplies
For Parts and Supplies, go to www.BISSELL.ca and enter your model number in the search field.
Warranty
f you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Care by E-mail, telephone, or regular mail as described below.
Limited Three-Year Warranty
Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, upon receipt of the product BISSELL will repair or replace (with new, refurbished, lightly used, or remanufactured components or products), at BISSELL’s option, free of charge from the date of purchase by the original purchaser, for three years, any defective or malfunctioning part. See information below on “If your BISSELLproduct should require service”.
This warranty applies to product used for personal, and not commercial or rental service. This warranty does not apply to fans or routine maintenance components such as filters, belts, or brushes. Damage or malfunction caused by negligence, abuse, neglect, unauthorized repair, or any other use not in accordance with the User’s Guide is not covered.
BISSELL IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE ASSOCIATED WITH THE USE OF THIS PRODUCT. BISSELL’S LIABILITY WILL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT.
*EXCEPTIONS AND EXCLUSIONS FROM THE TERMS OF THE LIMITED WARRANTY
THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES, EITHER ORAL OR WRITTEN. ANY IMPLIED WARRANTIES WHICH MAY ARISE BY OPERATION OF LAW, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE THREE-YEAR DURATION FROM THE DATE OF PURCHASE AS DESCRIBED ABOVE.
NOTE: Please keep your original sales receipt. It provides proof of date of purchase in the event of a warranty claim.
Service
If your BISSELL product should require service:
Contact BISSELL Consumer Care to locate a BISSELL Authorized Service Center in your area. If you need information about repairs or replacement parts, or if you have questions about your warranty, contact BISSELL Consumer Care. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Care by E-mail, telephone, or regular mail as described below.
Limited Three-Year Warranty
Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, upon receipt of the product BISSELL will repair or replace (with new, refurbished, lightly used, or remanufactured components or products), at BISSELL’s option, free of charge from the date of purchase by the original purchaser, for three years, any defective or malfunctioning part.
See information below on “If your BISSELL product should require service”.
This warranty applies to product used for personal, and not commercial or rental service. This warranty does not apply to fans or routine maintenance components such as filters, belts, or brushes. Damage or malfunction caused by negligence, abuse, neglect, unauthorized repair, or any other use not in accordance with the User’s Guide is not covered.
BISSELL IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE ASSOCIATED WITH THE USE OF THIS PRODUCT. BISSELL’S LIABILITY WILL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT.
*EXCEPTIONS AND EXCLUSIONS FROM THE TERMS OF THE LIMITED WARRANTY
THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES, EITHER ORAL OR WRITTEN. ANY IMPLIED WARRANTIES WHICH MAY ARISE BY OPERATION OF LAW, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE THREE-YEAR DURATION FROM THE DATE OF PURCHASE AS DESCRIBED ABOVE.
Website: www.BISSELL.ca
E-mail: www.BISSELL.ca/email-us
Call:
BISSELL Consumer Care
1-800-263-2535
Monday – Friday 8am – 10pm ET
Saturday 9am – 8pm ET
Sunday 10am – 7pm ET
Please do not return this product to the store.
Other maintenance or service not included in the manual should be performed by an authorized service representative.
For any questions or concerns, BISSELL is happy to be of service. Contact us directly at 1-800-263-2535.