Loading manuals...

onn Bluetooth Boombox 100070575 User Manual


Learn all about the onn Bluetooth Boombox (model number 100070575) and how to pair it using Bluetooth using this handy guide.

onn Bluetooth Boombox 100070575 User Manual Image

Manufactured by onn

(all onn manuals)


Onn 100070575 Bluetooth Boombox User Manual

onn Bluetooth Boombox 100070575 manual front cover

Specification

  • Frequency Response:85Hz-20KHz
  • S/N Ration: ≥ 62dB
  • Output Power:2.5W*2(RMS)
  • Speaker:3″ *2

Inside Package

  • Speaker 1 pc
  • Aux Cable  1 pc
  • Charging line 1 pc
  • User Manual 1 pc

Caution

  1. Do not expose to dripping or splashing.
  2. Do not place any objects filled with water over the apparatus.
  3. Do not block the ventilation holes.
  4. When using high output signal don’t turn the volume to maximum to avoid distortion.

How to Pair With Bluetooth:

  1. Select the audio input to Bluetooth status
  2. Search Bluetooth device with the name “ENKOR ET 15”
  3. Connect the Bluetooth
  4. lf your Bluetooth device below 2.0 version, input password “0000” when connecting.

Front Panel

Front panel visual diagram

Meanings of the Light Indicators

Light indicator list with meanings

System connection diagram

Connectors visual diagram

NOTE: * Do not leave objects generating magnetism near the speakers.

Timing alarm

How to use the alarm

  • Enter the aux mode, long press this key( ►II ) to set the timing mode. ( the red light flashes)
  • In the timing mode, short press this key( ►II ) to select timed alarm. (1 hour, 2, 3 … 4 hours)
  • Alarm setting confirmation: long press this key( ►II ) to confirm completion and exit.(The red light stops flashing and becomes normally on)
  • When the alarm clock rings, press any key to stop the alarm

Note: the timing alarm is a one-time setting and does not repeat. If it is turned off, the timing alarm will be automatically canceled

FCC Caution:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet the general RF exposure requirements. The device can be used in portable exposure conditions without restriction.


More Manuals From onn