Page 2 of 4
« Previous Next »
Contents and Remote Battery Installation
Components OF LITHIUM-POLYMER BATTERY
“AA” batteries
REMOTE BATTERY INFORMATION
- Slide open battery compartment
- Install 6 “AA” batteries as shown in the diagram shown above
- Replace and close battery compartment
LITHIUM-POLYMER BATTERY WARNING
There is a risk of fire and personal injury if Li-Po battery is punctured, damaged or misused
- Never expose battery to extreme temperatures or moisture
- Do not subject battery to strong impacts
- Always keep battery away from flammable materials
- Only use manufacturer specified batter(ies), charger(s), and/or adapters, if applicable, specified by the manufacturer
- Battery is not serviceable
- Let battery cool to room temperature before charging
- While charging, never leave battery unattended
- Recycle or dispose of battery according to federal state and local laws
KEEP THIS INSTRUCTION MANUAL FOR REFERENCE
BATTERY WARNING
- Do not mix old and new batteries
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries
- Insert batteries using the correct polarity. Do not short-circuit the supply terminal
- Only use manufacturer specified batter(ies), charger(s), and/or adapters, if applicable, specified by the manufacturer
- Always use, replace, and recharge (if applicable) batteries under adult supervision.
CHARGING THE BATTERY
Note: The Battery Charger will light up when it is charging the battery and turn off when the battery is fully charged. Charge time is approximately 120 minutes.
Turn off the drone before charging.
Connect the Battery Charger to the Micro USB port on the Drone.
Connect USB connector to a power source.
Method for CHARGING BATTERY
Page 2 of 4
« Previous Next »
[View Manual Contents]
