Manufactured by VIOFO
Installation Method
Install using the mount
1 Slide the mount into the slot on the back of the camera.
2 Peel the glue protector off the sticker.
3 Choose a suitable location to install / mount the camera; ensuring that it provides the best possible view.
Connect to Car Charger
Plug the USB charging adapter into your vehicle’s 12V/24V female power socket. Insert the Mini USB cable’s male port into the camera’s female Mini USB port.
Note:
- For GPS version mount, use the female Mini USB port on the mount or on the camera’s side.
- For non-GPS version mounts, use the female Mini USB port on the camera’s side.
Adjust the View Angle
Adjust the angle by moving the lens up / down.
Tips:
- Do not turn on ‘Motion Detection’ unless your vehicle is parked. If ‘Motion Detection’ is enabled while driving, the camera may not record continuously.
- It is recommended to keep the G-sensor set to ‘Low’ (default setting).
- Do not install / mount the camera in a location that interferes with the driver’s visibility and safety.
- Install / mount the camera close to the rear view mirror so that both sides of the scene being recorded are equally covered by the camera’s FOV (field of view).
- To ensure a clear view on rainy days the lens should be positioned within the windshield wiper’s sweeping range.
- Do not install / mount the camera on or near airbag panels.
- Installation / mounting location should not be affected by sun control film (window tint). There should not be any other electronic equipment close to the camera for optimal performance.
Note: Do not install / mount the camera on or near an airbag panel or within the airbag’s working range. The manufacturer is not liable for any injury or death caused by the deployment of the airbag.
