Learn how to set up the Honeywell Thermostat with model number RTH5160 in this handy manual. You can find installation instructions as well as how to set the thermostat up to work with a heat pump. A troubleshooting and FAQs section in the final few pages may also contain the answer to your question.
Sections in this Manual
- Included in the box
- Tools you will need
- Tools you may need
-
Removing your old thermostat
- Turn power OFF
- Check that your system is off.
- Remove the old thermostat’s faceplate.
- Make sure there are no 120/240V wires.
- Take a picture of how your wiring looks right now.
- Record which R-wire(s) you have and write down the color of the wire(s).
- Record the remaining wires and write down the color of the wires.
- Disconnect the wires and remove the old wall plate.
- Installing your RTH5160 thermostat
- Bundle and insert wires through the UWP.
- Insert the wall anchors.
- Set R-switch position and insert R-wire(s).
- Connect remaining wires.
- Confirm wiring matches snapshot.
- Mount the UWP and close the door.
- Install batteries.
- Attach your thermostat.
- Turn your power ON.
- System Setup
- Wiring—conventional systems
- Wiring—heat pump
- Battery Replacement
- Alerts Screen
- Alerts Codes
- Troubleshooting
- 1-year limited warranty
- FAQs
Page 1 of 7
Next »
Honeywell RTH5160 Non-Programmable Thermostat
Included in the box
Tools you will need
Tools you may need
Page 1 of 7
Next »
[View Manual Contents]
