Honeywell Thermostat RTH5160 Manual

Sections in this Manual

1. Included in the box
2. Tools you will need
3. Tools you may need
4. Removing your old thermostat
   1. Turn power OFF
   2. Check that your system is off.
   3. Remove the old thermostat’s faceplate.
   4. Make sure there are no 120/240V wires.
   5. Take a picture of how your wiring looks right now.
   6. Record which R-wire(s) you have and write down the color of the wire(s).
   7. Record the remaining wires and write down the color of the wires.
   8. Disconnect the wires and remove the old wall plate.
   9. Installing your RTH5160 thermostat
   10. Bundle and insert wires through the UWP.
   11. Insert the wall anchors.
   12. Set R-switch position and insert R-wire(s).
   13. Connect remaining wires.
   14. Confirm wiring matches snapshot.
   15. Mount the UWP and close the door.
   16. Install batteries.
   17. Attach your thermostat.
   18. Turn your power ON.
5. System Setup
   1. Select System Setup options.
   2. System Setup options
   3. System operation settings
   4. System modes:
   5. Fan operation settings
   1. Fan modes:
6. Wiring—conventional systems
   1. Alternate wiring (conventional systems)
7. Wiring—heat pump
   1. Alternate wiring (for heat pumps only)
8. Battery Replacement
9. Alerts Screen
10. Alerts Codes
11. Troubleshooting
12. 1-year limited warranty
13. FAQs
    1. Customer Assistance