onn 5.1 Soundbar Manual

Sections in this Manual

Manufactured by onn

(all onn manuals)

Page 3 of 3 « Previous

Product Wall Mounting the first step

Drill 2 parallel holes ( 98mm each according to well type) in the wall. The distance between the holes should be58ornm.

Installation must be carried out by qualified personnel only. Incorrect assembly can result severe personal injury and property damage (If you intend to Install this product yourself, you must check for installations such as electrical wiring and plumbing that may be bunde inside the wall). It is the installer’s responsibility to verify that the wall will safely support the total load of the Soundbar.
Additional tools (not included) are required for the installation.
Do not overtighten screws.
Keep this instruction manual for future reference.
Use an electronic stud finder to check the wall type before drilling and mounting.

Product Wall Mounting the second step

Using a dowel to affix the sound bar to the wall

Product Wall Mounting the Third Step

3. Insert 1 screw TA 9.40mm (not included) into each anchor. Be sure to leaves 6mm gal, between the wall and the screw’s head. Lift the unit over the heads of the screws and slot into place

Battery Replacement for the Remote Control the First Step

Lift up the back cover to open the battery compartment of the remote control.

Battery Replacement for the Remote Control the Second Step

Insert two AAA two batteries. Make sure the (.) and (-) ends alba batteries match the (a) and (-) ends Indicated in the battery compartment.

Battery Replacement for the Remote Control the Third Step

Close the battery compartment cover.

Sealing the remote control after battery replacement

Remote Control Operation Range

The remote control sensor on the front unit is sensitive to the remote control’s commands up to a maximum of 15′ away and within a maximum of a 60 arc.