Maintenance and Care
When you’re done
- Make sure both power switches are in the OFF (O)position. Unplug power cord from outlet.
- Carefully remove mop pad from swivel head, as mop pad and lower assembly will be hot.
- Any water remaining in the water tank should be emptied prior to machine storage.
- Mop pad can be machine washed in warm water with mild detergent. Do not use bleach or fabric softeners. For best results, air dry.
- Wrap power cord around quick release cord wrap on side of Steam & Sweep.
- Wipe all surfaces of Steam & Sweep with a soft cloth. Store upright in a protected, dry area.
NOTE: If the steam output is reduced, the nozzle may be blocked. To remedy, unplug the unit, remove the swivel head from the lower body and pour the vinegar through the center tube of the swivel head “neck”. Clear the nozzle by inserting a paper clip into the brass spray tip located in the bottom of the lower body.
Replacing the water purification system
CAUTION: Upright storage of the Steam & Sweep with a wet mop pad may result in the formation of white marks on your floor. To remove the white marks, clean area with vinegar.
If you fill your Steam & Sweep cleaner with normal tap water, it is essential to check the filter and replace it when it is no longer effective. Change the filter when the bright green grains turn blue.
If the filter is not changed at the appropriate time, calcium deposits will accumulate on the heating element, causing damage or reduced performance.
To replace the filter, pull it up and away from the Steam & Sweep. Using distilled or demineralized water will maximize the performance of your filter.
To order a replacement filter, refer to the replacement parts section on page 10.
Tip: Using distilled or demineralized water will maximize the performance of your filter.
Tip: Be sure to use only a BISSELL water filter in your Steam & Sweep.
Troubleshooting
Reduced steam or no steam
Possible causes
- Water tank is empty
- Depleted water filter
- Blocked steam nozzle
Remedies
- Fill water tank
- Replace filter
- Refer to NOTE on bottom of page 9.
Other maintenance or service not included in the manual should be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
NOTE: There are no serviceable parts in the upper housing of this product.
Please do not return this product to the store.
For any questions or concerns, BISSELL is happy to be of service. Contact us directly at 1-800-237-7691.
Replacement parts
| Item | Part No. | Part Name |
| 1 | 3252-2 | Water filter |
| 2 | 203-2246 | Handle assembly with screw |
| 3 | 203-2243 | Water tank with cap and insert |
| 4 | 203-2168 | Storage hook with screws |
Additional accessories
| Item | Part No. | Part Name |
| 1 | 75F5A | Microfiber mop pads – 2 pack |
